Best Watchmaker Lathe-Mill For Sale near SPIVEY KS

In general, for the watch maker, they offer the perfect setup. Plus, the price is much better than a Swiss machine. Next they offer two brushless motor options; 750 watt and 1200 watt. I can’t foresee a watchmaker needing over the 750 watt model. According to GlockCNC.com, they can sell you the lathe complete with all their. Watchmakers like precision. This makes perfect sense because those gears are pounding against each other and still must keep accurate time.

When precision of your lathe cuts to down, so does everything else. Until now, there weren’t a great deal of options to turn a Taig to a machine similar to a Swiss excellent lathe. That’s all changed over the past few decades. A small company in Michigan known as GlockCNC.com currently makes strategically done updates. Two upgrades in particular. First, they’ve produced there own heavy duty headstock and spindles. Is this good news for the watchmaker and clockmakers? Normally, the OEM Taig lathe uses a very tiny dovetail system for it’s headstock. GlockCNC.com uses a much thicker chuck of aluminum without a”air gap” between the headstock and the mattress. This allows for better energy managing from vibration. Then let’s look at the headstock itself. If you put the OEM headstock right next to the GlockCNC headstock, you immediately seem the difference. The OEM looks almost wimpy by comparison. The GlockCNC casing has a lot more metal in it and allows for much bigger 62mm OD bearing. This allows for a larger spindle to be utilized. Let us talk about those spindles for a watchmakers lathe.

Their typical spindle has a OD and they shrink fit the bearings. They offer ER25, ER32, ER40 and even the huge ER50 collet chuck spindles. The through hole is from .30″ to .89″, depending upon which ER spindle arbor you select. I would suspect that many watch makers will be using the ER25 or ER32. This allows for very precision workpiece gripping. Additionally, the collets can be found anywhere. GlockCNC offers .0002″ TIR collets (that is about as accurate as you’ll get). On top of that, they also have adjustable ER nuts to dial out any residual runout. Needless to say, if you work piece is not straight, then it will make it a challenge to dial out the runout. But, what could be done is make your cut, turn the piece around then use the adjustable nut to dial out the TIR.

Video: watchmaker lathe in SPIVEY