Best Watchmaker Lathe-Mill For Sale near SMITH CENTER KS

In general, for the watchmaker near SMITH CENTER KS, they offer the perfect installation. Additionally, the price is far better than a Swiss machine. I can’t foresee a watchmaker needing over the 750 watt model. According to GlockCNC.com, they could sell you the lathe complete with their. Watchmakers like precision. This makes perfect sense because all those gears are pounding against each other and still must keep accurate time. When accuracy of your lathe cuts down, so does everything else. Until now, there weren’t a lot of options to turn a Taig into a machine similar to a excellent lathe. That is all changed over the last few decades. A small company in Michigan known as GlockCNC.com now makes smartly done upgrades.

Two upgrades in particular. To begin with, they have produced there own heavy duty headstock and spindles. Why is this good news for the watchmakers and clockmakers? Firstly, let’s look at the meaty headstock and how it attaches to the lathe. Typically, the OEM Taig lathe uses a very tiny dovetail system for it’s headstock. GlockCNC.com utilizes a much thicker chuck of aluminum with no”air gap” between the headstock and the mattress. This allows for better energy handling from vibration. Let’s look at the headstock itself. If you put the OEM headstock right next to the GlockCNC headstock, you immediately seem the difference. The GlockCNC casing has far more metal in it and allows for bigger OD bearing. This allows for a larger spindle to be used. The fact of the matter is, that, more spindle mass equals better vibration dampening. Let us talk about those spindles for a watchmakers lathe.

Their spindle includes a 30mm OD and they shrink fit the bearings. They offer ER25, ER32, ER40 as well as the huge ER50 collet chuck spindles. The through hole is from .30″ to .89″, depending upon which ER spindle arbor you select. I’d suspect that many watch makers will use the ER25 or ER32. This allows for very precision workpiece. Plus, the collets are available anywhere. GlockCNC offers .0002″ TIR collets (that is about as precise as you will get). In addition to that, they also have adjustable ER nuts to dial out any remaining runout. Needless to say, if you work piece is not straight, then it’ll make it a challenge to dial out the runout. But, what can be done is make your cut, turn the piece around then use the adjustable nut to dial out the TIR.

Video: watchmaker mill in SMITH CENTER