Best Watchmaker Lathe-Mill For Sale near SHAWNEE MISSION KS

In general, for the watch maker, they offer the perfect setup. Additionally, the price is much better than a Swiss machine.

Next they offer two brushless motor options; 750 watt and 1200 watt. I can’t foresee a watchmaker needing more than the 750 watt model. In accordance with GlockCNC.com, they could sell you the lathe complete with their. Normally, the OEM Taig lathe uses a very tiny dovetail system for it’s headstock. GlockCNC.com uses a much thicker chuck of aluminum without a”air gap” between the headstock and the bed. This allows for better energy handling from vibration. Next, let’s look at the headstock itself. If you place the OEM headstock right next to the GlockCNC headstock, you instantly seem the difference. The OEM looks almost wimpy by comparison. The GlockCNC casing has far more metal in it and allows for bigger OD bearing. This, then, allows for a larger spindle to be utilized. The fact of the matter is, that, more spindle mass equals better vibration dampening. Let’s talk about these spindles for a watchmakers lathe. This makes perfect sense because those gears are pounding against each other and still must keep accurate time.

When accuracy of your lathe cuts down, so does everything else. Until now, there weren’t a lot of options to turn a Taig to a machine similar to a Swiss quality lathe. That changed over the past few years. A small company in Michigan known as GlockCNC.com now makes smartly done upgrades. Two upgrades specifically. To begin with, they have produced there own heavy duty headstock and spindles. Is this good news for the watchmakers and clockmakers? Their spindle has a 30mm OD and they shrink fit the bearings.

For those in SHAWNEE MISSION, KS They offer ER25, ER32, ER40 as well as the enormous ER50 collet chuck spindles. The through hole is from .30″ to .89″, determined by which ER spindle arbor you select. I’d suspect that most watch makers will be using the ER25 or ER32. This allows for very precision workpiece gripping. Additionally, the collets are available anywhere. GlockCNC offers .0002″ TIR collets (that is about as accurate as you will get). In addition to that, they also have adjustable ER nuts to dial out any remaining runout. Of course, if you work piece is not straight, then it will make it a challenge to dial out the runout.

Video: watchmaker lathe in SHAWNEE MISSION