Best Watchmaker Lathe-Mill For Sale near SEVERANCE KS

In general, for the watchmaker near SEVERANCE KS, they offer the perfect installation. Plus, the price is much better than a Swiss machine. I can not foresee a watchmaker needing over the 750 watt model. According to GlockCNC.com, they can sell you the lathe complete with their. Watchmakers like precision. This makes perfect sense because those gears are pounding against each other and still need to keep accurate time. When accuracy of your lathe cuts down, so does everything else. Until now, there weren’t a lot of options to turn a Taig into a machine similar to a Swiss excellent lathe. That changed over the past few years. A small company in Michigan known as GlockCNC.com now makes smartly done upgrades.

Two upgrades specifically. First, they’ve made there own heavy duty headstock and spindles. Is this great news for the watchmakers and clockmakers? Normally, the OEM Taig lathe uses a very tiny dovetail system for it’s headstock. GlockCNC.com uses a much thicker chuck of aluminum without a”air gap” between the headstock and the bed. This allows for better energy handling from vibration. Then let’s look at the headstock itself. If you place the OEM headstock right next to the GlockCNC headstock, you immediately seem the difference. The OEM looks almost wimpy by comparison. The GlockCNC casing has a metal inside and allows for much bigger 62mm OD bearing. This, in turn, allows for a larger spindle to be used. Let’s talk about those spindles for a watchmakers lathe.

Their typical spindle has a 30mm OD and they shrink fit the bearings into the spindle. They offer ER25, ER32, ER40 as well as the enormous ER50 collet chuck spindles. The through hole is from .30″ to .89″, depending upon which ER spindle arbor you select. I would suspect that most watch makers will use the ER25 or ER32. This allows for very precision workpiece gripping. Additionally, the collets are available anywhere. GlockCNC offers .0002″ TIR collets (that is about as accurate as you’ll get). On top of that, they also have adjustable ER nuts to dial out any remaining runout. Needless to say, if you work piece isn’t straight, then it will make it a challenge to dial out the runout. But, what could be done is make your cut, turn the piece around then use the adjustable nut to dial out the TIR.

Video: watchmaker lathe in SEVERANCE