Best Watchmaker Lathe-Mill For Sale near PERRY KS

In general, for the watchmaker near PERRY KS, they offer the perfect setup. Additionally, the price is far better than a Swiss machine. I can’t foresee a watchmaker needing more than the 750 watt model. According to GlockCNC.com, they can sell you the lathe complete with all their. Watchmakers like precision. This makes perfect sense because all those gears are pounding against each other and still must keep accurate time. When accuracy of your lathe cuts down, so does everything else. Until now, there weren’t a great deal of options to turn a Taig into a machine much like a excellent lathe. That changed over the past few years. A small company in Michigan known as GlockCNC.com currently makes strategically done updates.

Two upgrades specifically. To begin with, they have produced there own heavy duty headstock and spindles. Is this great news for the watchmakers and clockmakers? Normally, the OEM Taig lathe uses a very tiny dovetail system for it’s headstock. GlockCNC.com uses a much thicker chuck of aluminum with no”air gap” between the headstock and the bed. This allows for better energy managing from vibration. Next, let’s look at the headstock itself. If you place the OEM headstock right next to the GlockCNC headstock, you immediately seem the difference. The GlockCNC casing has a metal in it and allows for bigger OD bearing. This, then, allows for a larger spindle to be used. The fact of the matter is, that, more spindle mass equals better vibration dampening. Let us talk about those spindles for a watchmakers lathe.

Their typical spindle includes a OD and they shrink fit the bearings to the spindle. They offer ER25, ER32, ER40 and even the huge ER50 collet chuck spindles. The through hole is from .30″ to .89″, determined by which ER spindle arbor you choose. I would suspect that most watch makers will be using the ER25 or ER32. This allows for very precision workpiece. Plus, the collets can be found anywhere. GlockCNC offers .0002″ TIR collets (which is about as accurate as you will get). In addition to that, they also have adjustable ER nuts to dial out any residual runout. Needless to say, if you work piece is not straight, then it’ll make it a challenge to dial out the runout. But, what could be done is make your cut, turn the piece around then use the adjustable nut to dial out the TIR.

Video: watchmaker mill in PERRY