Best Watchmaker Lathe-Mill For Sale near PENALOSA KS
All in all, for the watchmaker near PENALOSA KS, they offer the perfect setup. Additionally, the price is far better than a Swiss machine. I can not foresee a watchmaker needing more than the 750 watt model. In accordance with GlockCNC.com, they could sell you the lathe complete with all their. This makes perfect sense because all those gears are pounding against each other and still must keep accurate time. When precision of your lathe cuts to down, so does everything else. Until now, there weren’t a lot of options to turn a Taig into a machine similar to a excellent lathe. That’s all changed over the last few decades. A small company in Michigan called GlockCNC.com currently makes strategically done upgrades.
Two upgrades in particular. First, they have produced there own heavy duty headstock and spindles. Is this good news for the watchmakers and clockmakers? Firstly, let’s look at the meaty headstock and how it attaches to the lathe. Typically, the OEM Taig lathe uses a very tiny dovetail system for it’s headstock. GlockCNC.com uses a much thicker chuck of aluminum without a”air gap” between the headstock and the bed. This allows for better energy managing from vibration. Let’s look at the headstock itself. If you place the OEM headstock right next to the GlockCNC headstock, you immediately seem the difference. The OEM looks almost wimpy by comparison. The GlockCNC casing has a lot more metal inside and allows for much bigger OD bearing. This allows for a larger spindle to be used. The simple fact of the matter is, that, more spindle mass equals better vibration dampening. Let’s talk about those spindles for a watchmakers lathe.
Their typical spindle includes a OD and they shrink fit the bearings to the spindle. They offer ER25, ER32, ER40 as well as the huge ER50 collet chuck spindles. The through hole is from .30″ to .89″, determined by which ER spindle arbor you choose. I would suspect that most watch makers will use the ER25 or ER32. This allows for very precision workpiece. Additionally, the collets are available anywhere. GlockCNC offers .0002″ TIR collets (which is about as precise as you’ll get). In addition to that, they also have adjustable ER nuts to dial out any residual runout. Of course, when you work piece isn’t straight, then it will make it a challenge to dial out the runout.
Video: watchmaker mill in PENALOSA