Best Watchmaker Lathe-Mill For Sale near NEWTON KS

In general, for the watch maker, they offer the perfect setup. Plus, the price is far better than a Swiss machine.

Next they offer two brushless motor options; 750 watt and 1200 watt. I can not foresee a watchmaker needing over the 750 watt model. In accordance with GlockCNC.com, they could sell you the lathe complete with their. Normally, the OEM Taig lathe uses a very tiny dovetail system for it’s headstock. GlockCNC.com uses a much thicker chuck of aluminum without a”air gap” between the headstock and the bed. This allows for better energy handling from vibration. Then let’s look at the headstock itself. If you put the OEM headstock right alongside the GlockCNC headstock, you immediately seem the difference. The OEM looks almost wimpy by comparison. The GlockCNC casing has far more metal inside and allows for bigger OD bearing. This, then, allows for a larger spindle to be utilized. The simple fact of the matter is, that, more spindle mass equals better vibration dampening. Let us talk about those spindles for a watchmakers lathe. Watchmakers like precision. This makes perfect sense because those gears are pounding against each other and still must keep accurate time.

When accuracy of your lathe cuts down, so does everything else. Until now, there weren’t a great deal of options to turn a Taig into a machine similar to a Swiss quality lathe. That changed over the last few years. A small business in Michigan called GlockCNC.com now makes smartly done updates. Two upgrades in particular. First, they’ve made there own heavy duty headstock and spindles. Is this good news for the watchmakers and clockmakers? Their typical spindle has a 30mm OD and they shrink fit the bearings.

For those in NEWTON, KS They offer ER25, ER32, ER40 as well as the enormous ER50 collet chuck spindles. The through hole is from .30″ to .89″, determined by which ER spindle arbor you choose. I would suspect that most watch makers will be using the ER25 or ER32. This allows for very precision workpiece gripping. Plus, the collets can be found anywhere. GlockCNC offers .0002″ TIR collets (that is about as precise as you’ll get). On top of that, they also have adjustable ER nuts to dial out any residual runout. Needless to say, if you work piece isn’t straight, then it’ll make it a challenge to dial out the runout.

Video: watchmaker mill in NEWTON