Best Watchmaker Lathe-Mill For Sale near MULBERRY KS

In general, for the watchmaker near MULBERRY KS, they offer the perfect setup. Additionally, the price is much better than a Swiss machine. I can not foresee a watchmaker needing more than the 750 watt model. According to GlockCNC.com, they can sell you the lathe complete with their. Watchmakers like precision. This makes perfect sense because all those gears are pounding against each other and still need to keep accurate time. When precision of your lathe cuts to down, so does everything else. Until now, there weren’t a lot of options to turn a Taig to a machine similar to a Swiss quality lathe. That’s all changed over the last few decades. A small company in Michigan known as GlockCNC.com now makes smartly done upgrades.

Two upgrades in particular. First, they have produced there own heavy duty headstock and spindles. Is this good news for the watchmakers and clockmakers? Firstly, let’s look at the meaty headstock and how it attaches to the lathe. Typically, the OEM Taig lathe uses a really tiny dovetail system for it’s headstock. GlockCNC.com utilizes a much thicker chuck of aluminum with no”air gap” between the headstock and the bed. This allows for better energy managing from vibration. Next, let’s look at the headstock itself. If you place the OEM headstock right next to the GlockCNC headstock, you immediately seem the difference. The OEM looks almost wimpy by comparison. The GlockCNC casing has far more metal in it and allows for much bigger OD bearing. This, in turn, allows for a larger spindle to be used. The simple fact of the matter is, that, more spindle mass equals better vibration dampening. Let us talk about these spindles for a watchmakers lathe.

Their typical spindle includes a 30mm OD and they shrink fit the bearings into the spindle. They offer ER25, ER32, ER40 and even the enormous ER50 collet chuck spindles. The through hole is from .30″ to .89″, depending upon which ER spindle arbor you choose. I would suspect that many watch makers will be using the ER25 or ER32. This allows for very precision workpiece gripping. Additionally, the collets can be found anywhere. GlockCNC offers .0002″ TIR collets (which is about as accurate as you will get). On top of that, they also have adjustable ER nuts to dial out any remaining runout. Needless to say, when you work piece isn’t straight, then it will make it a challenge to dial out the runout. But, what could be done is make your cut, turn the piece around then use the adjustable nut to dial out the TIR.

Video: watchmaker mill in MULBERRY