Best Watchmaker Lathe-Mill For Sale near MC CRACKEN KS
In general, for the watchmaker near MC CRACKEN KS, they offer the perfect setup. Additionally, the price is much better than a Swiss machine. I can’t foresee a watchmaker needing more than the 750 watt model. In accordance with GlockCNC.com, they can sell you the lathe complete with all their. This makes perfect sense because all those gears are pounding against each other and still must keep accurate time. When accuracy of your lathe cuts to down, so does everything else. Until now, there weren’t a lot of options to turn a Taig into a machine similar to a excellent lathe. That changed over the past few years. A small company in Michigan known as GlockCNC.com now makes smartly done updates.
Two upgrades in particular. To begin with, they have made there own heavy duty headstock and spindles. Why is this good news for the watchmakers and clockmakers? Firstly, let’s look at the meaty headstock and how it attaches to the lathe. Normally, the OEM Taig lathe uses a very tiny dovetail system for it’s headstock. GlockCNC.com utilizes a much thicker chuck of aluminum without a”air gap” between the headstock and the bed. This allows for better energy managing from vibration. Let’s look at the headstock itself. If you place the OEM headstock right next to the GlockCNC headstock, you instantly seem the difference. The GlockCNC casing has a metal in it and allows for bigger 62mm OD bearing. This allows for a larger spindle to be utilized. The fact of the matter is, that, more spindle mass equals better vibration dampening. Let’s talk about these spindles for a watchmakers lathe.
Their spindle has a 30mm OD and they shrink fit the bearings into the spindle. They offer ER25, ER32, ER40 and even the enormous ER50 collet chuck spindles. The through hole is from .30″ to .89″, determined by which ER spindle arbor you select. I’d suspect that most watch makers will use the ER25 or ER32. This allows for very precision workpiece. Additionally, the collets are available anywhere. GlockCNC offers .0002″ TIR collets (which is about as precise as you’ll get). On top of that, they also have adjustable ER nuts to dial out any remaining runout. Needless to say, when you work piece isn’t straight, then it will make it a challenge to dial out the runout.
Video: watchmaker lathe in MC CRACKEN