Best Watchmaker Lathe-Mill For Sale near LURAY KS
In general, for the watch maker, they offer the perfect setup. Additionally, the price is much better than a Swiss machine.
Next they offer two brushless motor options; 750 watt and 1200 watt. I can not foresee a watchmaker needing more than the 750 watt model. According to GlockCNC.com, they can sell you the lathe complete with their. Firstly, let us look at the meaty headstock and how it attaches to the lathe. Typically, the OEM Taig lathe uses a very tiny dovetail system for it’s headstock. GlockCNC.com uses a much thicker chuck of aluminum without a”air gap” between the headstock and the bed. This allows for better energy managing from vibration. Next, let’s look at the headstock itself. If you put the OEM headstock right alongside the GlockCNC headstock, you instantly seem the difference. The OEM looks almost wimpy by comparison. The GlockCNC casing has a lot more metal in it and allows for bigger OD bearing. This, in turn, allows for a larger spindle to be used. The fact of the matter is, that, more spindle mass equals better vibration dampening. Let’s talk about these spindles for a watchmakers lathe. Watchmakers like precision. This makes perfect sense because all those gears are pounding against each other and still must keep accurate time.
When precision of your lathe cuts to down, so does everything else. Until now, there weren’t a great deal of options to turn a Taig into a machine much like a Swiss excellent lathe. That changed over the last few decades. A small company in Michigan called GlockCNC.com currently makes strategically done upgrades. Two upgrades in particular. To begin with, they’ve produced there own heavy duty headstock and spindles. Is this great news for the watchmakers and clockmakers? Their typical spindle has a OD and they shrink fit the bearings.
For those in LURAY, KS They offer ER25, ER32, ER40 and even the enormous ER50 collet chuck spindles. The through hole is from .30″ to .89″, depending upon which ER spindle arbor you choose. I’d suspect that most watch makers will be using the ER25 or ER32. This allows for very precision workpiece gripping. Additionally, the collets can be found anywhere. GlockCNC offers .0002″ TIR collets (that is about as accurate as you will get). On top of that, they also have adjustable ER nuts to dial out any remaining runout. Of course, if you work piece is not straight, then it will make it a challenge to dial out the runout.
Video: watchmaker lathe in LURAY