Best Watchmaker Lathe-Mill For Sale near LAKE QUIVIRA KS

All in all, for the watch maker, they offer the perfect installation. Additionally, the price is far better than a Swiss machine.

I can not foresee a watchmaker needing more than the 750 watt model. In accordance with GlockCNC.com, they could sell you the lathe complete with all their. Firstly, let us look at the meaty headstock and how it attaches to the lathe. Normally, the OEM Taig lathe uses a very tiny dovetail system for it’s headstock. GlockCNC.com uses a much thicker chuck of aluminum without a”air gap” between the headstock and the mattress. This allows for better energy managing from vibration. Next, let’s look at the headstock itself. If you place the OEM headstock right next to the GlockCNC headstock, you immediately seem the difference. The GlockCNC casing has a metal in it and allows for much bigger OD bearing. This, in turn, allows for a larger spindle to be utilized. The fact of the matter is, that, more spindle mass equals better vibration dampening. Let us talk about those spindles for a watchmakers lathe. Watchmakers like precision. This makes perfect sense because those gears are pounding against each other and still must keep accurate time.

When accuracy of your lathe cuts down, so does everything else. Until now, there weren’t a lot of options to turn a Taig into a machine similar to a Swiss quality lathe. That changed over the last few decades. A small company in Michigan known as GlockCNC.com now makes smartly done upgrades. Two upgrades specifically. To begin with, they have produced there own heavy duty headstock and spindles. Is this good news for the watchmakers and clockmakers? Their spindle has a 30mm OD and they shrink fit the bearings.

For those in LAKE QUIVIRA, KS They offer ER25, ER32, ER40 as well as the huge ER50 collet chuck spindles. The through hole is from .30″ to .89″, determined by which ER spindle arbor you choose. I would suspect that many watch makers will use the ER25 or ER32. This allows for very precision workpiece gripping. Plus, the collets can be found anywhere. GlockCNC offers .0002″ TIR collets (which is about as accurate as you’ll get). In addition to that, they also have adjustable ER nuts to dial out any remaining runout. Needless to say, if you work piece is not straight, then it will make it a challenge to dial out the runout. But, what could be done is make your cut, turn the piece around then use the adjustable nut to dial out the TIR.

Video: watchmaker lathe in LAKE QUIVIRA