Best Watchmaker Lathe-Mill For Sale near KANORADO KS

All in all, for the watch maker, they offer the perfect setup. Additionally, the price is much better than a Swiss machine. Next they offer two brushless motor options; 750 watt and 1200 watt. I can’t foresee a watchmaker needing more than the 750 watt model. In accordance with GlockCNC.com, they could sell you the lathe complete with their. Watchmakers like precision. This makes perfect sense because all those gears are pounding against each other and still must keep accurate time.

When precision of your lathe cuts to down, so does everything else. Until now, there weren’t a lot of options to turn a Taig into a machine similar to a quality lathe. That is all changed over the last few decades. A small business in Michigan known as GlockCNC.com now makes smartly done upgrades. Two upgrades specifically. To begin with, they’ve produced there own heavy duty headstock and spindles. Is this good news for the watchmaker and clockmakers? Firstly, let us look at the meaty headstock and how it attaches to the lathe. Normally, the OEM Taig lathe uses a really tiny dovetail system for it’s headstock. GlockCNC.com utilizes a much thicker chuck of aluminum with no”air gap” between the headstock and the bed. This allows for better energy managing from vibration. Let’s look at the headstock itself. If you place the OEM headstock right alongside the GlockCNC headstock, you immediately seem the difference. The GlockCNC casing has a metal inside and allows for bigger 62mm OD bearing. This allows for a larger spindle to be utilized. The simple fact of the matter is, that, more spindle mass equals better vibration dampening. Let us talk about these spindles for a watchmakers lathe.

Their normal spindle includes a OD and they shrink fit the bearings. They offer ER25, ER32, ER40 and even the enormous ER50 collet chuck spindles. The through hole is from .30″ to .89″, determined by which ER spindle arbor you choose. I would suspect that most watch makers will use the ER25 or ER32. This allows for very precision workpiece gripping. Plus, the collets can be found anywhere. GlockCNC offers .0002″ TIR collets (that is about as precise as you’ll get). In addition to that, they also have adjustable ER nuts to dial out any remaining runout. Of course, if you work piece isn’t straight, then it will make it a challenge to dial out the runout. But, what can be done is make your cut, turn the piece around then use the adjustable nut to dial out the TIR.

Video: watchmaker lathe in KANORADO