Best Watchmaker Lathe-Mill For Sale near GARNETT KS
In general, for the watchmaker near GARNETT KS, they offer the perfect installation. Plus, the price is much better than a Swiss machine. I can’t foresee a watchmaker needing over the 750 watt model. According to GlockCNC.com, they can sell you the lathe complete with all their. This makes perfect sense because all those gears are pounding against each other and still need to keep accurate time. When precision of your lathe cuts down, so does everything else. Until now, there weren’t a lot of options to turn a Taig to a machine similar to a quality lathe. That changed over the last few years. A small business in Michigan called GlockCNC.com currently makes strategically done upgrades.
Two upgrades in particular. First, they’ve made there own heavy duty headstock and spindles. Is this great news for the watchmakers and clockmakers? Normally, the OEM Taig lathe uses a really tiny dovetail system for it’s headstock. GlockCNC.com uses a much thicker chuck of aluminum with no”air gap” between the headstock and the bed. This allows for better energy managing from vibration. Let’s look at the headstock itself. If you put the OEM headstock right next to the GlockCNC headstock, you immediately seem the difference. The OEM looks almost wimpy by comparison. The GlockCNC casing has a metal in it and allows for much bigger OD bearing. This, in turn, allows for a larger spindle to be used. The fact of the matter is, that, more spindle mass equals better vibration dampening. Let us talk about these spindles for a watchmakers lathe.
Their typical spindle has a 30mm OD and they shrink fit the bearings to the spindle. They offer ER25, ER32, ER40 and even the enormous ER50 collet chuck spindles. The through hole is from .30″ to .89″, determined by which ER spindle arbor you choose. I would suspect that many watch makers will use the ER25 or ER32. This allows for very precision workpiece gripping. Plus, the collets can be found anywhere. GlockCNC offers .0002″ TIR collets (that is about as accurate as you’ll get). On top of that, they also have adjustable ER nuts to dial out any residual runout. Needless to say, if you work piece isn’t straight, then it’ll make it a challenge to dial out the runout. But, what could be done is make your cut, turn the piece around then use the adjustable nut to dial out the TIR.
Video: watchmaker lathe in GARNETT