Best Watchmaker Lathe-Mill For Sale near GALESBURG KS

In general, for the watchmaker near GALESBURG KS, they offer the perfect setup. Additionally, the price is far better than a Swiss machine. I can’t foresee a watchmaker needing over the 750 watt model. According to GlockCNC.com, they could sell you the lathe complete with all their. This makes perfect sense because those gears are pounding against each other and still must keep accurate time. When accuracy of your lathe cuts to down, so does everything else. Until now, there weren’t a lot of options to turn a Taig to a machine much like a Swiss excellent lathe. That changed over the past few years. A small company in Michigan known as GlockCNC.com currently makes strategically done upgrades.

Two upgrades specifically. First, they have produced there own heavy duty headstock and spindles. Is this good news for the watchmakers and clockmakers? Firstly, let’s look at the meaty headstock and how it attaches to the lathe. Typically, the OEM Taig lathe uses a really tiny dovetail system for it’s headstock. GlockCNC.com utilizes a much thicker chuck of aluminum with no”air gap” between the headstock and the bed. This allows for better energy handling from vibration. Let’s look at the headstock itself. If you put the OEM headstock right alongside the GlockCNC headstock, you immediately seem the difference. The OEM looks almost wimpy by comparison. The GlockCNC casing has a metal inside and allows for much bigger 62mm OD bearing. This, in turn, allows for a larger spindle to be used. Let’s talk about these spindles for a watchmakers lathe.

Their typical spindle includes a OD and they shrink fit the bearings to the spindle. They offer ER25, ER32, ER40 as well as the enormous ER50 collet chuck spindles. The through hole is from .30″ to .89″, depending upon which ER spindle arbor you choose. I would suspect that most watch makers will use the ER25 or ER32. This allows for very precision workpiece. Plus, the collets are available anywhere. GlockCNC offers .0002″ TIR collets (that is about as accurate as you’ll get). On top of that, they also have adjustable ER nuts to dial out any remaining runout. Of course, if you work piece is not straight, then it will make it a challenge to dial out the runout.

Video: watchmaker mill in GALESBURG