Best Watchmaker Lathe-Mill For Sale near FELLSBURG KS

All in all, for the watch maker, they offer the perfect setup. Additionally, the price is much better than a Swiss machine. Next they offer two brushless motor options; 750 watt and 1200 watt. I can not foresee a watchmaker needing over the 750 watt model. In accordance with GlockCNC.com, they can sell you the lathe complete with their. This makes perfect sense because all those gears are pounding against each other and still must keep accurate time.

When precision of your lathe cuts to down, so does everything else. Until now, there weren’t a lot of options to turn a Taig to a machine similar to a excellent lathe. That is all changed over the last few decades. A small company in Michigan called GlockCNC.com now makes smartly done updates. Two upgrades in particular. To begin with, they have made there own heavy duty headstock and spindles. Why is this good news for the watchmaker and clockmakers? Normally, the OEM Taig lathe uses a really tiny dovetail system for it’s headstock. GlockCNC.com uses a much thicker chuck of aluminum with no”air gap” between the headstock and the bed. This allows for better energy managing from vibration. Then let’s look at the headstock itself. If you put the OEM headstock right next to the GlockCNC headstock, you instantly seem the difference. The GlockCNC casing has a metal inside and allows for much bigger OD bearing. This allows for a larger spindle to be utilized. The fact of the matter is, that, more spindle mass equals better vibration dampening. Let’s talk about those spindles for a watchmakers lathe.

Their spindle has a 30mm OD and they shrink fit the bearings to the spindle. They offer ER25, ER32, ER40 as well as the enormous ER50 collet chuck spindles. The through hole is from .30″ to .89″, determined by which ER spindle arbor you select. I would suspect that most watch makers will be using the ER25 or ER32. This allows for very precision workpiece. Additionally, the collets can be found anywhere. GlockCNC offers .0002″ TIR collets (that is about as precise as you will get). On top of that, they also have adjustable ER nuts to dial out any remaining runout. Needless to say, if you work piece is not straight, then it’ll make it a challenge to dial out the runout. But, what could be done is make your cut, turn the piece around then use the adjustable nut to dial out the TIR.

Video: watchmaker mill in FELLSBURG