Best Watchmaker Lathe-Mill For Sale near ENSIGN KS

In general, for the watch maker, they offer the perfect setup. Plus, the price is much better than a Swiss machine.

Next they offer two brushless motor options; 750 watt and 1200 watt. I can’t foresee a watchmaker needing more than the 750 watt model. According to GlockCNC.com, they could sell you the lathe complete with their. Firstly, let’s look at the meaty headstock and how it attaches to the lathe. Normally, the OEM Taig lathe uses a really tiny dovetail system for it’s headstock. GlockCNC.com utilizes a much thicker chuck of aluminum without a”air gap” between the headstock and the mattress. This allows for better energy handling from vibration. Next, let’s look at the headstock itself. If you put the OEM headstock right next to the GlockCNC headstock, you immediately seem the difference. The GlockCNC casing has a lot more metal inside and allows for much bigger 62mm OD bearing. This allows for a larger spindle to be utilized. The fact of the matter is, that, more spindle mass equals better vibration dampening. Let’s talk about those spindles for a watchmakers lathe. Watchmakers like precision. This makes perfect sense because all those gears are pounding against each other and still must keep accurate time.

When accuracy of your lathe cuts to down, so does everything else. Until now, there weren’t a great deal of options to turn a Taig into a machine similar to a Swiss excellent lathe. That is all changed over the last few years. A small business in Michigan known as GlockCNC.com currently makes strategically done upgrades. Two upgrades specifically. First, they’ve produced there own heavy duty headstock and spindles. Is this good news for the watchmakers and clockmakers? Their spindle has a 30mm OD and they shrink fit the bearings.

For those in ENSIGN, KS They offer ER25, ER32, ER40 and even the huge ER50 collet chuck spindles. The through hole is from .30″ to .89″, depending upon which ER spindle arbor you select. I’d suspect that most watch makers will use the ER25 or ER32. This allows for very precision workpiece gripping. Additionally, the collets can be found anywhere. GlockCNC offers .0002″ TIR collets (which is about as precise as you will get). On top of that, they also have adjustable ER nuts to dial out any residual runout. Of course, when you work piece isn’t straight, then it’ll make it a challenge to dial out the runout.