Best Watchmaker Lathe-Mill For Sale near DWIGHT KS

All in all, for the watch maker, they offer the perfect setup. Plus, the price is much better than a Swiss machine.

Next they offer two brushless motor options; 750 watt and 1200 watt. I can not foresee a watchmaker needing more than the 750 watt model. According to GlockCNC.com, they could sell you the lathe complete with their. Typically, the OEM Taig lathe uses a very tiny dovetail system for it’s headstock. GlockCNC.com uses a much thicker chuck of aluminum without a”air gap” between the headstock and the mattress. This allows for better energy managing from vibration. Next, let’s look at the headstock itself. If you put the OEM headstock right next to the GlockCNC headstock, you instantly seem the difference. The OEM looks almost wimpy by comparison. The GlockCNC casing has a metal in it and allows for bigger OD bearing. This allows for a larger spindle to be used. Let’s talk about these spindles for a watchmakers lathe. Watchmakers like precision. This makes perfect sense because those gears are pounding against each other and still must keep accurate time.

When precision of your lathe cuts to down, so does everything else. Until now, there weren’t a lot of options to turn a Taig into a machine much like a Swiss quality lathe. That’s all changed over the past few years. A small business in Michigan known as GlockCNC.com currently makes strategically done upgrades. Two upgrades in particular. First, they have made there own heavy duty headstock and spindles. Is this good news for the watchmakers and clockmakers? Their spindle has a 30mm OD and they shrink fit the bearings to the spindle.

For those in DWIGHT, KS They offer ER25, ER32, ER40 as well as the huge ER50 collet chuck spindles. The through hole is from .30″ to .89″, depending upon which ER spindle arbor you select. I’d suspect that most watch makers will use the ER25 or ER32. This allows for very precision workpiece. Additionally, the collets can be found anywhere. GlockCNC offers .0002″ TIR collets (that is about as precise as you will get). In addition to that, they also have adjustable ER nuts to dial out any remaining runout. Needless to say, if you work piece is not straight, then it will make it a challenge to dial out the runout.

Video: watchmaker mill in DWIGHT