Best Watchmaker Lathe-Mill For Sale near CEDAR POINT KS
In general, for the watch maker, they offer the perfect setup. Additionally, the price is far better than a Swiss machine.
I can not foresee a watchmaker needing over the 750 watt model. In accordance with GlockCNC.com, they could sell you the lathe complete with their. Firstly, let us look at the meaty headstock and how it attaches to the lathe. Typically, the OEM Taig lathe uses a really tiny dovetail system for it’s headstock. GlockCNC.com uses a much thicker chuck of aluminum without a”air gap” between the headstock and the mattress. This allows for better energy handling from vibration. Then let’s look at the headstock itself. If you put the OEM headstock right next to the GlockCNC headstock, you instantly seem the difference. The GlockCNC casing has a metal inside and allows for bigger 62mm OD bearing. This, in turn, allows for a larger spindle to be utilized. The fact of the matter is, that, more spindle mass equals better vibration dampening. Let’s talk about these spindles for a watchmakers lathe. This makes perfect sense because those gears are pounding against each other and still must keep accurate time.
When precision of your lathe cuts down, so does everything else. Until now, there weren’t a great deal of options to turn a Taig to a machine similar to a Swiss quality lathe. That changed over the past few decades. A small business in Michigan called GlockCNC.com currently makes strategically done upgrades. Two upgrades specifically. First, they have made there own heavy duty headstock and spindles. Is this good news for the watchmakers and clockmakers? Their typical spindle includes a 30mm OD and they shrink fit the bearings.
For those in CEDAR POINT, KS They offer ER25, ER32, ER40 and even the enormous ER50 collet chuck spindles. The through hole is from .30″ to .89″, depending upon which ER spindle arbor you choose. I’d suspect that many watch makers will use the ER25 or ER32. This allows for very precision workpiece. Plus, the collets can be found anywhere. GlockCNC offers .0002″ TIR collets (which is about as accurate as you will get). In addition to that, they also have adjustable ER nuts to dial out any residual runout. Needless to say, when you work piece is not straight, then it’ll make it a challenge to dial out the runout. But, what could be done is make your cut, turn the piece around then use the adjustable nut to dial out the TIR.
Video: watchmaker mill in CEDAR POINT