Best Watchmaker Lathe-Mill For Sale near CARLYLE KS

In general, for the watch maker, they offer the perfect setup. Additionally, the price is much better than a Swiss machine.

Next they offer two brushless motor options; 750 watt and 1200 watt. I can’t foresee a watchmaker needing over the 750 watt model. According to GlockCNC.com, they can sell you the lathe complete with their. Typically, the OEM Taig lathe uses a very tiny dovetail system for it’s headstock. GlockCNC.com uses a much thicker chuck of aluminum with no”air gap” between the headstock and the mattress. This allows for better energy handling from vibration. Let’s look at the headstock itself. If you place the OEM headstock right alongside the GlockCNC headstock, you immediately seem the difference. The GlockCNC casing has a lot more metal inside and allows for much bigger OD bearing. This allows for a larger spindle to be used. The fact of the matter is, that, more spindle mass equals better vibration dampening. Let us talk about those spindles for a watchmakers lathe. Watchmakers like precision. This makes perfect sense because all those gears are pounding against each other and still must keep accurate time.

When accuracy of your lathe cuts to down, so does everything else. Until now, there weren’t a great deal of options to turn a Taig to a machine similar to a quality lathe. That changed over the last few decades. A small company in Michigan known as GlockCNC.com now makes smartly done upgrades. Two upgrades specifically. To begin with, they have produced there own heavy duty headstock and spindles. Why is this good news for the watchmakers and clockmakers? Their spindle includes a 30mm OD and they shrink fit the bearings.

For those in CARLYLE, KS They offer ER25, ER32, ER40 and even the enormous ER50 collet chuck spindles. The through hole is from .30″ to .89″, depending upon which ER spindle arbor you select. I’d suspect that most watch makers will be using the ER25 or ER32. This allows for very precision workpiece gripping. Plus, the collets can be found anywhere. GlockCNC offers .0002″ TIR collets (which is about as precise as you’ll get). In addition to that, they also have adjustable ER nuts to dial out any residual runout. Of course, when you work piece is not straight, then it’ll make it a challenge to dial out the runout.

Video: watchmaker mill in CARLYLE