Best Watchmaker Lathe-Mill For Sale near RED DEVIL AK
All in all, for the watchmaker near RED DEVIL AK, they offer the perfect setup. Plus, the price is far better than a Swiss machine. I can not foresee a watchmaker needing over the 750 watt model. In accordance with GlockCNC.com, they could sell you the lathe complete with their. This makes perfect sense because those gears are pounding against each other and still must keep accurate time. When accuracy of your lathe cuts down, so does everything else. Until now, there weren’t a lot of options to turn a Taig to a machine similar to a Swiss quality lathe. That changed over the last few decades. A small company in Michigan known as GlockCNC.com now makes smartly done upgrades.
Two upgrades specifically. To begin with, they’ve made there own heavy duty headstock and spindles. Why is this good news for the watchmakers and clockmakers? Typically, the OEM Taig lathe uses a really tiny dovetail system for it’s headstock. GlockCNC.com uses a much thicker chuck of aluminum without a”air gap” between the headstock and the mattress. This allows for better energy managing from vibration. Next, let’s look at the headstock itself. If you place the OEM headstock right next to the GlockCNC headstock, you instantly seem the difference. The OEM looks almost wimpy by comparison. The GlockCNC casing has a metal in it and allows for bigger OD bearing. This, then, allows for a larger spindle to be utilized. Let’s talk about these spindles for a watchmakers lathe.
Their typical spindle includes a OD and they shrink fit the bearings to the spindle. They offer ER25, ER32, ER40 and even the enormous ER50 collet chuck spindles. The through hole is from .30″ to .89″, determined by which ER spindle arbor you choose. I would suspect that many watch makers will use the ER25 or ER32. This allows for very precision workpiece gripping. Additionally, the collets are available anywhere. GlockCNC offers .0002″ TIR collets (which is about as accurate as you’ll get). On top of that, they also have adjustable ER nuts to dial out any remaining runout. Needless to say, if you work piece is not straight, then it’ll make it a challenge to dial out the runout. But, what can be done is make your cut, turn the piece around then use the adjustable nut to dial out the TIR.
Video: watchmaker lathe in RED DEVIL