Best Watchmaker Lathe-Mill For Sale near FOLSOM PA
All in all, for the watchmaker near FOLSOM PA, they offer the perfect setup. Additionally, the price is much better than a Swiss machine. I can’t foresee a watchmaker needing over the 750 watt model. According to GlockCNC.com, they could sell you the lathe complete with all their. This makes perfect sense because those gears are pounding against each other and still must keep accurate time. When accuracy of your lathe cuts down, so does everything else. Until now, there weren’t a lot of options to turn a Taig to a machine similar to a excellent lathe. That’s all changed over the past few years. A small company in Michigan known as GlockCNC.com currently makes strategically done upgrades.
Two upgrades specifically. First, they’ve made there own heavy duty headstock and spindles. Is this good news for the watchmakers and clockmakers? Firstly, let’s look at the meaty headstock and how it attaches to the lathe. Normally, the OEM Taig lathe uses a really tiny dovetail system for it’s headstock. GlockCNC.com uses a much thicker chuck of aluminum with no”air gap” between the headstock and the mattress. This allows for better energy handling from vibration. Next, let’s look at the headstock itself. If you place the OEM headstock right next to the GlockCNC headstock, you instantly seem the difference. The GlockCNC casing has far more metal inside and allows for much bigger OD bearing. This allows for a larger spindle to be utilized. Let us talk about those spindles for a watchmakers lathe.
Their spindle has a 30mm OD and they shrink fit the bearings to the spindle. They offer ER25, ER32, ER40 and even the enormous ER50 collet chuck spindles. The through hole is from .30″ to .89″, determined by which ER spindle arbor you choose. I’d suspect that most watch makers will be using the ER25 or ER32. This allows for very precision workpiece gripping. Plus, the collets can be found anywhere. GlockCNC offers .0002″ TIR collets (which is about as precise as you’ll get). On top of that, they also have adjustable ER nuts to dial out any remaining runout. Of course, if you work piece isn’t straight, then it will make it a challenge to dial out the runout. But, what could be done is make your cut, turn the piece around then use the adjustable nut to dial out the TIR.
Video: watchmaker mill in FOLSOM