Best Watchmaker Lathe-Mill For Sale near GRATIOT OH

In general, for the watch maker, they offer the perfect installation. Additionally, the price is much better than a Swiss machine.

Next they offer two brushless motor options; 750 watt and 1200 watt. I can not foresee a watchmaker needing more than the 750 watt model. In accordance with GlockCNC.com, they could sell you the lathe complete with their. Firstly, let’s look at the meaty headstock and how it attaches to the lathe. Typically, the OEM Taig lathe uses a really tiny dovetail system for it’s headstock. GlockCNC.com utilizes a much thicker chuck of aluminum with no”air gap” between the headstock and the mattress. This allows for better energy handling from vibration. Let’s look at the headstock itself. If you place the OEM headstock right next to the GlockCNC headstock, you immediately seem the difference. The OEM looks almost wimpy by comparison. The GlockCNC casing has far more metal in it and allows for much bigger 62mm OD bearing. This, in turn, allows for a larger spindle to be used. The simple fact of the matter is, that, more spindle mass equals better vibration dampening. Let us talk about these spindles for a watchmakers lathe. This makes perfect sense because those gears are pounding against each other and still must keep accurate time.

When accuracy of your lathe cuts down, so does everything else. Until now, there weren’t a great deal of options to turn a Taig into a machine similar to a quality lathe. That’s all changed over the past few decades. A small business in Michigan called GlockCNC.com now makes smartly done upgrades. Two upgrades specifically. To begin with, they have made there own heavy duty headstock and spindles. Is this good news for the watchmakers and clockmakers? Their typical spindle includes a OD and they shrink fit the bearings.

For those in GRATIOT, OH They offer ER25, ER32, ER40 and even the huge ER50 collet chuck spindles. The through hole is from .30″ to .89″, depending upon which ER spindle arbor you choose. I would suspect that many watch makers will be using the ER25 or ER32. This allows for very precision workpiece. Plus, the collets are available anywhere. GlockCNC offers .0002″ TIR collets (that is about as precise as you’ll get). On top of that, they also have adjustable ER nuts to dial out any remaining runout. Needless to say, when you work piece isn’t straight, then it’ll make it a challenge to dial out the runout. But, what could be done is make your cut, turn the piece around then use the adjustable nut to dial out the TIR.

Video: watchmaker mill in GRATIOT