Best Watchmaker Lathe-Mill For Sale near BAYONNE NJ

All in all, for the watchmaker near BAYONNE NJ, they offer the perfect setup. Plus, the price is far better than a Swiss machine. I can not foresee a watchmaker needing more than the 750 watt model. According to GlockCNC.com, they could sell you the lathe complete with all their. This makes perfect sense because those gears are pounding against each other and still must keep accurate time. When precision of your lathe cuts to down, so does everything else. Until now, there weren’t a lot of options to turn a Taig into a machine similar to a excellent lathe. That’s all changed over the past few decades. A small business in Michigan called GlockCNC.com currently makes strategically done updates.

Two upgrades specifically. To begin with, they’ve made there own heavy duty headstock and spindles. Is this good news for the watchmakers and clockmakers? Normally, the OEM Taig lathe uses a very tiny dovetail system for it’s headstock. GlockCNC.com uses a much thicker chuck of aluminum with no”air gap” between the headstock and the mattress. This allows for better energy handling from vibration. Let’s look at the headstock itself. If you place the OEM headstock right alongside the GlockCNC headstock, you instantly seem the difference. The GlockCNC casing has far more metal in it and allows for much bigger 62mm OD bearing. This, in turn, allows for a larger spindle to be utilized. The fact of the matter is, that, more spindle mass equals better vibration dampening. Let’s talk about these spindles for a watchmakers lathe.

Their spindle has a 30mm OD and they shrink fit the bearings into the spindle. They offer ER25, ER32, ER40 as well as the enormous ER50 collet chuck spindles. The through hole is from .30″ to .89″, determined by which ER spindle arbor you choose. I would suspect that many watch makers will be using the ER25 or ER32. This allows for very precision workpiece. Additionally, the collets can be found anywhere. GlockCNC offers .0002″ TIR collets (which is about as accurate as you will get). In addition to that, they also have adjustable ER nuts to dial out any remaining runout. Needless to say, if you work piece is not straight, then it will make it a challenge to dial out the runout.

Video: watchmaker lathe in BAYONNE