Best Watchmaker Lathe-Mill For Sale near LANAI CITY HI
In general, for the watchmaker near LANAI CITY HI, they offer the perfect setup. Additionally, the price is much better than a Swiss machine. Next they offer two brushless motor options; 750 watt and 1200 watt. I can’t foresee a watchmaker needing more than the 750 watt model. According to GlockCNC.com, they could sell you the lathe complete with all their. This makes perfect sense because those gears are pounding against each other and still need to keep accurate time. When accuracy of your lathe cuts down, so does everything else. Until now, there weren’t a lot of options to turn a Taig to a machine similar to a excellent lathe. That is all changed over the last few years. A small company in Michigan called GlockCNC.com currently makes strategically done upgrades.
Two upgrades specifically. First, they’ve produced there own heavy duty headstock and spindles. Is this great news for the watchmakers and clockmakers? Firstly, let’s look at the meaty headstock and how it attaches to the lathe. Normally, the OEM Taig lathe uses a really tiny dovetail system for it’s headstock. GlockCNC.com uses a much thicker chuck of aluminum with no”air gap” between the headstock and the mattress. This allows for better energy handling from vibration. Let’s look at the headstock itself. If you place the OEM headstock right next to the GlockCNC headstock, you instantly seem the difference. The OEM looks almost wimpy by comparison. The GlockCNC casing has far more metal inside and allows for bigger 62mm OD bearing. This allows for a larger spindle to be utilized. The fact of the matter is, that, more spindle mass equals better vibration dampening. Let us talk about these spindles for a watchmakers lathe.
Their typical spindle includes a OD and they shrink fit the bearings. They offer ER25, ER32, ER40 and even the huge ER50 collet chuck spindles. The through hole is from .30″ to .89″, depending upon which ER spindle arbor you select. I’d suspect that most watch makers will use the ER25 or ER32. This allows for very precision workpiece gripping. Additionally, the collets can be found anywhere. GlockCNC offers .0002″ TIR collets (which is about as accurate as you will get). On top of that, they also have adjustable ER nuts to dial out any residual runout. Of course, when you work piece isn’t straight, then it will make it a challenge to dial out the runout. But, what could be done is make your cut, turn the piece around then use the adjustable nut to dial out the TIR.
Video: watchmaker lathe in LANAI CITY