Best Watchmaker Lathe-Mill For Sale near RAILROAD FLAT CA

In general, for the watchmaker near RAILROAD FLAT CA, they offer the perfect setup. Additionally, the price is far better than a Swiss machine. I can’t foresee a watchmaker needing more than the 750 watt model. According to GlockCNC.com, they could sell you the lathe complete with all their. This makes perfect sense because those gears are pounding against each other and still must keep accurate time. When precision of your lathe cuts to down, so does everything else. Until now, there weren’t a lot of options to turn a Taig to a machine similar to a Swiss excellent lathe. That is all changed over the past few years. A small company in Michigan called GlockCNC.com now makes smartly done upgrades.

Two upgrades specifically. To begin with, they have made there own heavy duty headstock and spindles. Is this good news for the watchmakers and clockmakers? Firstly, let’s look at the meaty headstock and how it attaches to the lathe. Typically, the OEM Taig lathe uses a really tiny dovetail system for it’s headstock. GlockCNC.com utilizes a much thicker chuck of aluminum with no”air gap” between the headstock and the mattress. This allows for better energy handling from vibration. Next, let’s look at the headstock itself. If you place the OEM headstock right alongside the GlockCNC headstock, you instantly seem the difference. The OEM looks almost wimpy by comparison. The GlockCNC casing has a metal inside and allows for much bigger OD bearing. This, in turn, allows for a larger spindle to be used. The fact of the matter is, that, more spindle mass equals better vibration dampening. Let us talk about these spindles for a watchmakers lathe.

Their normal spindle has a 30mm OD and they shrink fit the bearings. They offer ER25, ER32, ER40 as well as the huge ER50 collet chuck spindles. The through hole is from .30″ to .89″, determined by which ER spindle arbor you select. I’d suspect that many watch makers will use the ER25 or ER32. This allows for very precision workpiece gripping. Plus, the collets are available anywhere. GlockCNC offers .0002″ TIR collets (that is about as accurate as you’ll get). On top of that, they also have adjustable ER nuts to dial out any remaining runout. Of course, when you work piece is not straight, then it’ll make it a challenge to dial out the runout.

Video: watchmaker lathe in RAILROAD FLAT