Best Watchmaker Lathe-Mill For Sale near PLEASANT VALLEY CA

All in all, for the watch maker, they offer the perfect installation. Plus, the price is far better than a Swiss machine.

Next they offer two brushless motor options; 750 watt and 1200 watt. I can’t foresee a watchmaker needing over the 750 watt model. In accordance with GlockCNC.com, they could sell you the lathe complete with their. Normally, the OEM Taig lathe uses a really tiny dovetail system for it’s headstock. GlockCNC.com uses a much thicker chuck of aluminum without a”air gap” between the headstock and the bed. This allows for better energy handling from vibration. Next, let’s look at the headstock itself. If you put the OEM headstock right next to the GlockCNC headstock, you immediately seem the difference. The OEM looks almost wimpy by comparison. The GlockCNC casing has a lot more metal inside and allows for bigger 62mm OD bearing. This, then, allows for a larger spindle to be utilized. Let’s talk about these spindles for a watchmakers lathe. This makes perfect sense because all those gears are pounding against each other and still need to keep accurate time.

When accuracy of your lathe cuts to down, so does everything else. Until now, there weren’t a lot of options to turn a Taig into a machine much like a quality lathe. That’s all changed over the last few decades. A small company in Michigan known as GlockCNC.com now makes smartly done updates. Two upgrades specifically. To begin with, they have made there own heavy duty headstock and spindles. Is this good news for the watchmakers and clockmakers? Their typical spindle has a OD and they shrink fit the bearings.

For those in PLEASANT VALLEY, CA They offer ER25, ER32, ER40 and even the huge ER50 collet chuck spindles. The through hole is from .30″ to .89″, depending upon which ER spindle arbor you choose. I’d suspect that many watch makers will use the ER25 or ER32. This allows for very precision workpiece gripping. Plus, the collets can be found anywhere. GlockCNC offers .0002″ TIR collets (which is about as precise as you will get). In addition to that, they also have adjustable ER nuts to dial out any remaining runout. Needless to say, if you work piece isn’t straight, then it’ll make it a challenge to dial out the runout. But, what can be done is make your cut, turn the piece around then use the adjustable nut to dial out the TIR.

Video: watchmaker lathe in PLEASANT VALLEY