Best Watchmaker Lathe-Mill For Sale near PINNACLES CA

In general, for the watch maker, they offer the perfect installation. Additionally, the price is far better than a Swiss machine. I can not foresee a watchmaker needing over the 750 watt model. In accordance with GlockCNC.com, they can sell you the lathe complete with their. Watchmakers like precision. This makes perfect sense because all those gears are pounding against each other and still must keep accurate time.

When accuracy of your lathe cuts down, so does everything else. Until now, there weren’t a lot of options to turn a Taig to a machine similar to a Swiss quality lathe. That changed over the past few years. A small business in Michigan called GlockCNC.com now makes smartly done upgrades. Two upgrades in particular. To begin with, they have made there own heavy duty headstock and spindles. Is this great news for the watchmaker and clockmakers? Typically, the OEM Taig lathe uses a really tiny dovetail system for it’s headstock. GlockCNC.com uses a much thicker chuck of aluminum without a”air gap” between the headstock and the bed. This allows for better energy managing from vibration. Next, let’s look at the headstock itself. If you place the OEM headstock right alongside the GlockCNC headstock, you immediately seem the difference. The OEM looks almost wimpy by comparison. The GlockCNC casing has a metal in it and allows for much bigger 62mm OD bearing. This allows for a larger spindle to be used. The simple fact of the matter is, that, more spindle mass equals better vibration dampening. Let’s talk about these spindles for a watchmakers lathe.

Their spindle includes a 30mm OD and they shrink fit the bearings into the spindle. They offer ER25, ER32, ER40 and even the huge ER50 collet chuck spindles. The through hole is from .30″ to .89″, depending upon which ER spindle arbor you select. I would suspect that most watch makers will use the ER25 or ER32. This allows for very precision workpiece gripping. Plus, the collets are available anywhere. GlockCNC offers .0002″ TIR collets (which is about as accurate as you will get). On top of that, they also have adjustable ER nuts to dial out any remaining runout. Needless to say, when you work piece is not straight, then it’ll make it a challenge to dial out the runout.

Video: watchmaker lathe in PINNACLES