Best Watchmaker Lathe-Mill For Sale near PENTZ CA

In general, for the watch maker, they offer the perfect setup. Plus, the price is much better than a Swiss machine. I can not foresee a watchmaker needing over the 750 watt model. In accordance with GlockCNC.com, they can sell you the lathe complete with all their. This makes perfect sense because those gears are pounding against each other and still must keep accurate time.

When accuracy of your lathe cuts down, so does everything else. Until now, there weren’t a lot of options to turn a Taig to a machine much like a excellent lathe. That changed over the past few decades. A small company in Michigan known as GlockCNC.com currently makes strategically done updates. Two upgrades in particular. First, they have produced there own heavy duty headstock and spindles. Why is this good news for the watchmaker and clockmakers? Firstly, let us look at the meaty headstock and how it attaches to the lathe. Typically, the OEM Taig lathe uses a very tiny dovetail system for it’s headstock. GlockCNC.com uses a much thicker chuck of aluminum with no”air gap” between the headstock and the bed. This allows for better energy managing from vibration. Then let’s look at the headstock itself. If you put the OEM headstock right next to the GlockCNC headstock, you instantly seem the difference. The GlockCNC casing has a lot more metal inside and allows for bigger 62mm OD bearing. This, then, allows for a larger spindle to be utilized. The fact of the matter is, that, more spindle mass equals better vibration dampening. Let us talk about those spindles for a watchmakers lathe.

Their typical spindle includes a 30mm OD and they shrink fit the bearings into the spindle. They offer ER25, ER32, ER40 as well as the huge ER50 collet chuck spindles. The through hole is from .30″ to .89″, depending upon which ER spindle arbor you select. I would suspect that most watch makers will use the ER25 or ER32. This allows for very precision workpiece. Plus, the collets can be found anywhere. GlockCNC offers .0002″ TIR collets (that is about as precise as you will get). On top of that, they also have adjustable ER nuts to dial out any residual runout. Needless to say, if you work piece is not straight, then it will make it a challenge to dial out the runout. But, what can be done is make your cut, turn the piece around then use the adjustable nut to dial out the TIR.

Video: watchmaker lathe in PENTZ