Best Watchmaker Lathe-Mill For Sale near PENNINGTON CA

In general, for the watch maker, they offer the perfect setup. Plus, the price is much better than a Swiss machine.

I can not foresee a watchmaker needing more than the 750 watt model. In accordance with GlockCNC.com, they can sell you the lathe complete with their. Normally, the OEM Taig lathe uses a really tiny dovetail system for it’s headstock. GlockCNC.com utilizes a much thicker chuck of aluminum without a”air gap” between the headstock and the bed. This allows for better energy handling from vibration. Next, let’s look at the headstock itself. If you put the OEM headstock right alongside the GlockCNC headstock, you immediately seem the difference. The OEM looks almost wimpy by comparison. The GlockCNC casing has a metal inside and allows for much bigger 62mm OD bearing. This, in turn, allows for a larger spindle to be used. The simple fact of the matter is, that, more spindle mass equals better vibration dampening. Let us talk about these spindles for a watchmakers lathe. This makes perfect sense because all those gears are pounding against each other and still must keep accurate time.

When precision of your lathe cuts down, so does everything else. Until now, there weren’t a lot of options to turn a Taig to a machine similar to a quality lathe. That changed over the past few decades. A small company in Michigan known as GlockCNC.com currently makes strategically done upgrades. Two upgrades in particular. To begin with, they have produced there own heavy duty headstock and spindles. Why is this good news for the watchmakers and clockmakers? Their typical spindle includes a OD and they shrink fit the bearings.

For those in PENNINGTON, CA They offer ER25, ER32, ER40 and even the huge ER50 collet chuck spindles. The through hole is from .30″ to .89″, determined by which ER spindle arbor you choose. I’d suspect that most watch makers will be using the ER25 or ER32. This allows for very precision workpiece. Additionally, the collets are available anywhere. GlockCNC offers .0002″ TIR collets (that is about as accurate as you will get). In addition to that, they also have adjustable ER nuts to dial out any remaining runout. Needless to say, if you work piece isn’t straight, then it’ll make it a challenge to dial out the runout.

Video: watchmaker mill in PENNINGTON