Best Watchmaker Lathe-Mill For Sale near PELICAN BAY STATE PRISON CA
In general, for the watch maker, they offer the perfect installation. Plus, the price is far better than a Swiss machine.
Next they offer two brushless motor options; 750 watt and 1200 watt. I can’t foresee a watchmaker needing more than the 750 watt model. According to GlockCNC.com, they can sell you the lathe complete with their. Firstly, let’s look at the meaty headstock and how it attaches to the lathe. Normally, the OEM Taig lathe uses a very tiny dovetail system for it’s headstock. GlockCNC.com utilizes a much thicker chuck of aluminum without a”air gap” between the headstock and the bed. This allows for better energy handling from vibration. Next, let’s look at the headstock itself. If you place the OEM headstock right next to the GlockCNC headstock, you instantly seem the difference. The GlockCNC casing has a metal inside and allows for much bigger OD bearing. This, in turn, allows for a larger spindle to be utilized. The fact of the matter is, that, more spindle mass equals better vibration dampening. Let us talk about those spindles for a watchmakers lathe. This makes perfect sense because all those gears are pounding against each other and still must keep accurate time.
When precision of your lathe cuts down, so does everything else. Until now, there weren’t a lot of options to turn a Taig to a machine much like a quality lathe. That’s all changed over the last few decades. A small business in Michigan known as GlockCNC.com currently makes strategically done updates. Two upgrades in particular. To begin with, they have made there own heavy duty headstock and spindles. Why is this great news for the watchmakers and clockmakers? Their normal spindle has a OD and they shrink fit the bearings into the spindle.
For those in PELICAN BAY STATE PRISON, CA They offer ER25, ER32, ER40 and even the huge ER50 collet chuck spindles. The through hole is from .30″ to .89″, determined by which ER spindle arbor you choose. I’d suspect that most watch makers will be using the ER25 or ER32. This allows for very precision workpiece gripping. Plus, the collets are available anywhere. GlockCNC offers .0002″ TIR collets (which is about as accurate as you’ll get). On top of that, they also have adjustable ER nuts to dial out any remaining runout. Needless to say, if you work piece is not straight, then it will make it a challenge to dial out the runout. But, what could be done is make your cut, turn the piece around then use the adjustable nut to dial out the TIR.
Video: watchmaker mill in PELICAN BAY STATE PRISON