Best Watchmaker Lathe-Mill For Sale near ORANGE COVE CA

In general, for the watch maker, they offer the perfect installation. Plus, the price is much better than a Swiss machine.

I can not foresee a watchmaker needing more than the 750 watt model. According to GlockCNC.com, they can sell you the lathe complete with all their. Typically, the OEM Taig lathe uses a really tiny dovetail system for it’s headstock. GlockCNC.com uses a much thicker chuck of aluminum without a”air gap” between the headstock and the bed. This allows for better energy handling from vibration. Then let’s look at the headstock itself. If you place the OEM headstock right alongside the GlockCNC headstock, you immediately seem the difference. The OEM looks almost wimpy by comparison. The GlockCNC casing has far more metal in it and allows for bigger OD bearing. This allows for a larger spindle to be used. The fact of the matter is, that, more spindle mass equals better vibration dampening. Let’s talk about these spindles for a watchmakers lathe. This makes perfect sense because those gears are pounding against each other and still need to keep accurate time.

When accuracy of your lathe cuts down, so does everything else. Until now, there weren’t a lot of options to turn a Taig to a machine similar to a excellent lathe. That is all changed over the last few years. A small company in Michigan known as GlockCNC.com now makes smartly done upgrades. Two upgrades in particular. To begin with, they have made there own heavy duty headstock and spindles. Why is this good news for the watchmakers and clockmakers? Their spindle has a OD and they shrink fit the bearings to the spindle.

For those in ORANGE COVE, CA They offer ER25, ER32, ER40 and even the enormous ER50 collet chuck spindles. The through hole is from .30″ to .89″, determined by which ER spindle arbor you select. I’d suspect that most watch makers will use the ER25 or ER32. This allows for very precision workpiece. Additionally, the collets can be found anywhere. GlockCNC offers .0002″ TIR collets (which is about as accurate as you’ll get). On top of that, they also have adjustable ER nuts to dial out any residual runout. Of course, when you work piece isn’t straight, then it’ll make it a challenge to dial out the runout.

Video: watchmaker lathe in ORANGE COVE