Best Watchmaker Lathe-Mill For Sale near ONYX CA

All in all, for the watch maker, they offer the perfect setup. Additionally, the price is much better than a Swiss machine.

I can not foresee a watchmaker needing over the 750 watt model. In accordance with GlockCNC.com, they can sell you the lathe complete with their. Normally, the OEM Taig lathe uses a really tiny dovetail system for it’s headstock. GlockCNC.com utilizes a much thicker chuck of aluminum with no”air gap” between the headstock and the bed. This allows for better energy managing from vibration. Then let’s look at the headstock itself. If you put the OEM headstock right next to the GlockCNC headstock, you immediately seem the difference. The GlockCNC casing has a metal in it and allows for much bigger OD bearing. This, then, allows for a larger spindle to be used. The fact of the matter is, that, more spindle mass equals better vibration dampening. Let’s talk about these spindles for a watchmakers lathe. This makes perfect sense because those gears are pounding against each other and still must keep accurate time.

When precision of your lathe cuts to down, so does everything else. Until now, there weren’t a lot of options to turn a Taig to a machine much like a Swiss quality lathe. That changed over the last few decades. A small business in Michigan known as GlockCNC.com now makes smartly done updates. Two upgrades specifically. To begin with, they’ve produced there own heavy duty headstock and spindles. Is this good news for the watchmakers and clockmakers? Their typical spindle includes a 30mm OD and they shrink fit the bearings.

For those in ONYX, CA They offer ER25, ER32, ER40 as well as the huge ER50 collet chuck spindles. The through hole is from .30″ to .89″, depending upon which ER spindle arbor you choose. I would suspect that many watch makers will be using the ER25 or ER32. This allows for very precision workpiece. Additionally, the collets can be found anywhere. GlockCNC offers .0002″ TIR collets (which is about as precise as you will get). In addition to that, they also have adjustable ER nuts to dial out any remaining runout. Needless to say, if you work piece is not straight, then it will make it a challenge to dial out the runout. But, what can be done is make your cut, turn the piece around then use the adjustable nut to dial out the TIR.

Video: watchmaker lathe in ONYX