Best Watchmaker Lathe-Mill For Sale near NAVAL BASE VENTURA COUNTY CA

In general, for the watchmaker near NAVAL BASE VENTURA COUNTY CA, they offer the perfect setup. Additionally, the price is much better than a Swiss machine. Next they offer two brushless motor options; 750 watt and 1200 watt. I can’t foresee a watchmaker needing over the 750 watt model. According to GlockCNC.com, they can sell you the lathe complete with their. Watchmakers like precision. This makes perfect sense because all those gears are pounding against each other and still must keep accurate time. When accuracy of your lathe cuts to down, so does everything else. Until now, there weren’t a lot of options to turn a Taig to a machine much like a quality lathe. That’s all changed over the past few decades. A small company in Michigan known as GlockCNC.com now makes smartly done updates.

Two upgrades specifically. First, they’ve made there own heavy duty headstock and spindles. Why is this great news for the watchmakers and clockmakers? Firstly, let us look at the meaty headstock and how it attaches to the lathe. Normally, the OEM Taig lathe uses a really tiny dovetail system for it’s headstock. GlockCNC.com uses a much thicker chuck of aluminum with no”air gap” between the headstock and the mattress. This allows for better energy managing from vibration. Then let’s look at the headstock itself. If you put the OEM headstock right alongside the GlockCNC headstock, you instantly seem the difference. The OEM looks almost wimpy by comparison. The GlockCNC casing has far more metal inside and allows for much bigger 62mm OD bearing. This allows for a larger spindle to be used. The simple fact of the matter is, that, more spindle mass equals better vibration dampening. Let’s talk about those spindles for a watchmakers lathe.

Their normal spindle has a 30mm OD and they shrink fit the bearings into the spindle. They offer ER25, ER32, ER40 and even the huge ER50 collet chuck spindles. The through hole is from .30″ to .89″, determined by which ER spindle arbor you select. I would suspect that many watch makers will use the ER25 or ER32. This allows for very precision workpiece. Plus, the collets can be found anywhere. GlockCNC offers .0002″ TIR collets (which is about as precise as you’ll get). On top of that, they also have adjustable ER nuts to dial out any residual runout. Needless to say, when you work piece is not straight, then it will make it a challenge to dial out the runout. But, what could be done is make your cut, turn the piece around then use the adjustable nut to dial out the TIR.

Video: watchmaker mill in NAVAL BASE VENTURA COUNTY