Best Watchmaker Lathe-Mill For Sale near MONTECITO CA

In general, for the watchmaker near MONTECITO CA, they offer the perfect setup. Plus, the price is far better than a Swiss machine. I can not foresee a watchmaker needing over the 750 watt model. In accordance with GlockCNC.com, they could sell you the lathe complete with their. This makes perfect sense because all those gears are pounding against each other and still need to keep accurate time. When precision of your lathe cuts to down, so does everything else. Until now, there weren’t a lot of options to turn a Taig into a machine much like a Swiss excellent lathe. That changed over the past few years. A small business in Michigan known as GlockCNC.com currently makes strategically done upgrades.

Two upgrades in particular. First, they have produced there own heavy duty headstock and spindles. Why is this good news for the watchmakers and clockmakers? Normally, the OEM Taig lathe uses a really tiny dovetail system for it’s headstock. GlockCNC.com uses a much thicker chuck of aluminum without a”air gap” between the headstock and the bed. This allows for better energy handling from vibration. Let’s look at the headstock itself. If you place the OEM headstock right next to the GlockCNC headstock, you immediately seem the difference. The GlockCNC casing has a metal in it and allows for bigger OD bearing. This, then, allows for a larger spindle to be used. The simple fact of the matter is, that, more spindle mass equals better vibration dampening. Let’s talk about these spindles for a watchmakers lathe.

Their spindle has a OD and they shrink fit the bearings into the spindle. They offer ER25, ER32, ER40 as well as the enormous ER50 collet chuck spindles. The through hole is from .30″ to .89″, depending upon which ER spindle arbor you choose. I’d suspect that most watch makers will use the ER25 or ER32. This allows for very precision workpiece gripping. Additionally, the collets can be found anywhere. GlockCNC offers .0002″ TIR collets (that is about as accurate as you’ll get). On top of that, they also have adjustable ER nuts to dial out any residual runout. Of course, if you work piece is not straight, then it will make it a challenge to dial out the runout.

Video: watchmaker mill in MONTECITO