Best Watchmaker Lathe-Mill For Sale near MONTCLAIR CA

In general, for the watchmaker near MONTCLAIR CA, they offer the perfect installation. Additionally, the price is much better than a Swiss machine. Next they offer two brushless motor options; 750 watt and 1200 watt. I can not foresee a watchmaker needing over the 750 watt model. According to GlockCNC.com, they could sell you the lathe complete with all their. Watchmakers like precision. This makes perfect sense because those gears are pounding against each other and still must keep accurate time. When precision of your lathe cuts to down, so does everything else. Until now, there weren’t a lot of options to turn a Taig to a machine much like a quality lathe. That changed over the past few decades. A small company in Michigan known as GlockCNC.com currently makes strategically done upgrades.

Two upgrades specifically. First, they have made there own heavy duty headstock and spindles. Is this good news for the watchmakers and clockmakers? Firstly, let us look at the meaty headstock and how it attaches to the lathe. Normally, the OEM Taig lathe uses a very tiny dovetail system for it’s headstock. GlockCNC.com utilizes a much thicker chuck of aluminum without a”air gap” between the headstock and the bed. This allows for better energy managing from vibration. Next, let’s look at the headstock itself. If you put the OEM headstock right next to the GlockCNC headstock, you immediately seem the difference. The OEM looks almost wimpy by comparison. The GlockCNC casing has a metal inside and allows for much bigger 62mm OD bearing. This allows for a larger spindle to be utilized. The fact of the matter is, that, more spindle mass equals better vibration dampening. Let’s talk about those spindles for a watchmakers lathe.

Their normal spindle includes a OD and they shrink fit the bearings to the spindle. They offer ER25, ER32, ER40 and even the huge ER50 collet chuck spindles. The through hole is from .30″ to .89″, depending upon which ER spindle arbor you choose. I’d suspect that most watch makers will be using the ER25 or ER32. This allows for very precision workpiece. Plus, the collets are available anywhere. GlockCNC offers .0002″ TIR collets (which is about as accurate as you will get). On top of that, they also have adjustable ER nuts to dial out any remaining runout. Of course, if you work piece is not straight, then it will make it a challenge to dial out the runout.

Video: watchmaker lathe in MONTCLAIR