Best Watchmaker Lathe-Mill For Sale near MILPITAS CA

In general, for the watchmaker near MILPITAS CA, they offer the perfect setup. Plus, the price is much better than a Swiss machine. Next they offer two brushless motor options; 750 watt and 1200 watt. I can’t foresee a watchmaker needing over the 750 watt model. According to GlockCNC.com, they could sell you the lathe complete with all their. This makes perfect sense because those gears are pounding against each other and still need to keep accurate time. When precision of your lathe cuts down, so does everything else. Until now, there weren’t a great deal of options to turn a Taig to a machine similar to a Swiss quality lathe. That changed over the last few decades. A small company in Michigan called GlockCNC.com currently makes strategically done upgrades.

Two upgrades specifically. First, they have made there own heavy duty headstock and spindles. Is this good news for the watchmakers and clockmakers? Firstly, let us look at the meaty headstock and how it attaches to the lathe. Normally, the OEM Taig lathe uses a very tiny dovetail system for it’s headstock. GlockCNC.com utilizes a much thicker chuck of aluminum without a”air gap” between the headstock and the mattress. This allows for better energy managing from vibration. Then let’s look at the headstock itself. If you place the OEM headstock right next to the GlockCNC headstock, you immediately seem the difference. The OEM looks almost wimpy by comparison. The GlockCNC casing has a metal in it and allows for bigger OD bearing. This allows for a larger spindle to be used. The fact of the matter is, that, more spindle mass equals better vibration dampening. Let’s talk about these spindles for a watchmakers lathe.

Their normal spindle includes a OD and they shrink fit the bearings to the spindle. They offer ER25, ER32, ER40 and even the enormous ER50 collet chuck spindles. The through hole is from .30″ to .89″, depending upon which ER spindle arbor you choose. I would suspect that many watch makers will use the ER25 or ER32. This allows for very precision workpiece. Additionally, the collets can be found anywhere. GlockCNC offers .0002″ TIR collets (which is about as accurate as you’ll get). On top of that, they also have adjustable ER nuts to dial out any residual runout. Of course, if you work piece isn’t straight, then it’ll make it a challenge to dial out the runout. But, what can be done is make your cut, turn the piece around then use the adjustable nut to dial out the TIR.

Video: watchmaker lathe in MILPITAS