Best Watchmaker Lathe-Mill For Sale near MICHIGAN BLUFF CA
In general, for the watch maker, they offer the perfect setup. Plus, the price is far better than a Swiss machine. I can not foresee a watchmaker needing over the 750 watt model. According to GlockCNC.com, they could sell you the lathe complete with all their. This makes perfect sense because those gears are pounding against each other and still need to keep accurate time.
When precision of your lathe cuts to down, so does everything else. Until now, there weren’t a lot of options to turn a Taig to a machine much like a Swiss excellent lathe. That’s all changed over the past few years. A small business in Michigan called GlockCNC.com now makes smartly done updates. Two upgrades in particular. First, they’ve produced there own heavy duty headstock and spindles. Why is this great news for the watchmaker and clockmakers? Firstly, let’s look at the meaty headstock and how it attaches to the lathe. Typically, the OEM Taig lathe uses a very tiny dovetail system for it’s headstock. GlockCNC.com uses a much thicker chuck of aluminum with no”air gap” between the headstock and the mattress. This allows for better energy handling from vibration. Next, let’s look at the headstock itself. If you put the OEM headstock right next to the GlockCNC headstock, you immediately seem the difference. The GlockCNC casing has a metal in it and allows for much bigger 62mm OD bearing. This allows for a larger spindle to be utilized. The fact of the matter is, that, more spindle mass equals better vibration dampening. Let’s talk about those spindles for a watchmakers lathe.
Their typical spindle includes a 30mm OD and they shrink fit the bearings into the spindle. They offer ER25, ER32, ER40 as well as the huge ER50 collet chuck spindles. The through hole is from .30″ to .89″, determined by which ER spindle arbor you select. I would suspect that many watch makers will use the ER25 or ER32. This allows for very precision workpiece gripping. Additionally, the collets are available anywhere. GlockCNC offers .0002″ TIR collets (which is about as accurate as you’ll get). On top of that, they also have adjustable ER nuts to dial out any residual runout. Needless to say, if you work piece isn’t straight, then it will make it a challenge to dial out the runout. But, what can be done is make your cut, turn the piece around then use the adjustable nut to dial out the TIR.
Video: watchmaker lathe in MICHIGAN BLUFF