Best Watchmaker Lathe-Mill For Sale near MENTONE CA

All in all, for the watch maker, they offer the perfect setup. Additionally, the price is much better than a Swiss machine.

Next they offer two brushless motor options; 750 watt and 1200 watt. I can not foresee a watchmaker needing more than the 750 watt model. According to GlockCNC.com, they could sell you the lathe complete with their. Typically, the OEM Taig lathe uses a really tiny dovetail system for it’s headstock. GlockCNC.com uses a much thicker chuck of aluminum without a”air gap” between the headstock and the mattress. This allows for better energy managing from vibration. Next, let’s look at the headstock itself. If you place the OEM headstock right alongside the GlockCNC headstock, you instantly seem the difference. The GlockCNC casing has a metal inside and allows for much bigger 62mm OD bearing. This, then, allows for a larger spindle to be utilized. The fact of the matter is, that, more spindle mass equals better vibration dampening. Let us talk about those spindles for a watchmakers lathe. This makes perfect sense because those gears are pounding against each other and still must keep accurate time.

When accuracy of your lathe cuts down, so does everything else. Until now, there weren’t a lot of options to turn a Taig into a machine much like a Swiss quality lathe. That’s all changed over the past few decades. A small business in Michigan called GlockCNC.com currently makes strategically done updates. Two upgrades specifically. To begin with, they’ve produced there own heavy duty headstock and spindles. Is this good news for the watchmakers and clockmakers? Their typical spindle has a 30mm OD and they shrink fit the bearings to the spindle.

For those in MENTONE, CA They offer ER25, ER32, ER40 as well as the enormous ER50 collet chuck spindles. The through hole is from .30″ to .89″, depending upon which ER spindle arbor you select. I would suspect that most watch makers will be using the ER25 or ER32. This allows for very precision workpiece. Plus, the collets are available anywhere. GlockCNC offers .0002″ TIR collets (which is about as accurate as you will get). On top of that, they also have adjustable ER nuts to dial out any remaining runout. Needless to say, if you work piece is not straight, then it will make it a challenge to dial out the runout.

Video: watchmaker lathe in MENTONE