Best Watchmaker Lathe-Mill For Sale near MCKINLEYVILLE CA

In general, for the watch maker, they offer the perfect setup. Plus, the price is much better than a Swiss machine. I can’t foresee a watchmaker needing over the 750 watt model. In accordance with GlockCNC.com, they can sell you the lathe complete with all their. Watchmakers like precision. This makes perfect sense because those gears are pounding against each other and still need to keep accurate time.

When accuracy of your lathe cuts to down, so does everything else. Until now, there weren’t a lot of options to turn a Taig to a machine similar to a excellent lathe. That’s all changed over the last few years. A small company in Michigan known as GlockCNC.com currently makes strategically done updates. Two upgrades in particular. To begin with, they have produced there own heavy duty headstock and spindles. Why is this good news for the watchmaker and clockmakers? Normally, the OEM Taig lathe uses a very tiny dovetail system for it’s headstock. GlockCNC.com utilizes a much thicker chuck of aluminum with no”air gap” between the headstock and the bed. This allows for better energy managing from vibration. Let’s look at the headstock itself. If you place the OEM headstock right alongside the GlockCNC headstock, you immediately seem the difference. The OEM looks almost wimpy by comparison. The GlockCNC casing has a lot more metal inside and allows for much bigger 62mm OD bearing. This, in turn, allows for a larger spindle to be used. Let’s talk about these spindles for a watchmakers lathe.

Their normal spindle includes a OD and they shrink fit the bearings into the spindle. They offer ER25, ER32, ER40 as well as the enormous ER50 collet chuck spindles. The through hole is from .30″ to .89″, depending upon which ER spindle arbor you choose. I would suspect that most watch makers will use the ER25 or ER32. This allows for very precision workpiece gripping. Plus, the collets are available anywhere. GlockCNC offers .0002″ TIR collets (that is about as precise as you’ll get). On top of that, they also have adjustable ER nuts to dial out any remaining runout. Of course, if you work piece is not straight, then it’ll make it a challenge to dial out the runout. But, what can be done is make your cut, turn the piece around then use the adjustable nut to dial out the TIR.

Video: watchmaker lathe in MCKINLEYVILLE