Best Watchmaker Lathe-Mill For Sale near LOCKEFORD CA

In general, for the watch maker, they offer the perfect installation. Additionally, the price is far better than a Swiss machine.

I can not foresee a watchmaker needing more than the 750 watt model. In accordance with GlockCNC.com, they could sell you the lathe complete with their. Normally, the OEM Taig lathe uses a very tiny dovetail system for it’s headstock. GlockCNC.com utilizes a much thicker chuck of aluminum without a”air gap” between the headstock and the bed. This allows for better energy handling from vibration. Let’s look at the headstock itself. If you place the OEM headstock right next to the GlockCNC headstock, you immediately seem the difference. The GlockCNC casing has a lot more metal inside and allows for bigger OD bearing. This allows for a larger spindle to be utilized. Let us talk about these spindles for a watchmakers lathe. Watchmakers like precision. This makes perfect sense because those gears are pounding against each other and still need to keep accurate time.

When precision of your lathe cuts to down, so does everything else. Until now, there weren’t a lot of options to turn a Taig into a machine much like a quality lathe. That changed over the last few years. A small company in Michigan known as GlockCNC.com currently makes strategically done updates. Two upgrades specifically. To begin with, they have made there own heavy duty headstock and spindles. Is this good news for the watchmakers and clockmakers? Their typical spindle includes a 30mm OD and they shrink fit the bearings into the spindle.

For those in LOCKEFORD, CA They offer ER25, ER32, ER40 as well as the enormous ER50 collet chuck spindles. The through hole is from .30″ to .89″, determined by which ER spindle arbor you choose. I would suspect that many watch makers will be using the ER25 or ER32. This allows for very precision workpiece gripping. Additionally, the collets can be found anywhere. GlockCNC offers .0002″ TIR collets (that is about as accurate as you will get). In addition to that, they also have adjustable ER nuts to dial out any remaining runout. Needless to say, if you work piece is not straight, then it’ll make it a challenge to dial out the runout. But, what could be done is make your cut, turn the piece around then use the adjustable nut to dial out the TIR.

Video: watchmaker lathe in LOCKEFORD