Best Watchmaker Lathe-Mill For Sale near LIVINGSTON CA

All in all, for the watch maker, they offer the perfect installation. Plus, the price is far better than a Swiss machine.

I can not foresee a watchmaker needing over the 750 watt model. According to GlockCNC.com, they could sell you the lathe complete with all their. Normally, the OEM Taig lathe uses a very tiny dovetail system for it’s headstock. GlockCNC.com utilizes a much thicker chuck of aluminum without a”air gap” between the headstock and the mattress. This allows for better energy managing from vibration. Let’s look at the headstock itself. If you put the OEM headstock right next to the GlockCNC headstock, you instantly seem the difference. The GlockCNC casing has far more metal in it and allows for much bigger 62mm OD bearing. This, then, allows for a larger spindle to be used. The fact of the matter is, that, more spindle mass equals better vibration dampening. Let’s talk about these spindles for a watchmakers lathe. This makes perfect sense because those gears are pounding against each other and still must keep accurate time.

When precision of your lathe cuts down, so does everything else. Until now, there weren’t a lot of options to turn a Taig to a machine much like a excellent lathe. That is all changed over the past few decades. A small business in Michigan called GlockCNC.com currently makes strategically done upgrades. Two upgrades specifically. To begin with, they have produced there own heavy duty headstock and spindles. Why is this good news for the watchmakers and clockmakers? Their normal spindle includes a 30mm OD and they shrink fit the bearings.

For those in LIVINGSTON, CA They offer ER25, ER32, ER40 as well as the enormous ER50 collet chuck spindles. The through hole is from .30″ to .89″, determined by which ER spindle arbor you choose. I’d suspect that many watch makers will use the ER25 or ER32. This allows for very precision workpiece. Plus, the collets can be found anywhere. GlockCNC offers .0002″ TIR collets (which is about as accurate as you’ll get). In addition to that, they also have adjustable ER nuts to dial out any remaining runout. Needless to say, if you work piece isn’t straight, then it’ll make it a challenge to dial out the runout. But, what could be done is make your cut, turn the piece around then use the adjustable nut to dial out the TIR.

Video: watchmaker mill in LIVINGSTON