Best Watchmaker Lathe-Mill For Sale near LEESVILLE CA

In general, for the watch maker, they offer the perfect setup. Additionally, the price is far better than a Swiss machine.

Next they offer two brushless motor options; 750 watt and 1200 watt. I can’t foresee a watchmaker needing more than the 750 watt model. According to GlockCNC.com, they can sell you the lathe complete with all their. Normally, the OEM Taig lathe uses a really tiny dovetail system for it’s headstock. GlockCNC.com utilizes a much thicker chuck of aluminum without a”air gap” between the headstock and the bed. This allows for better energy handling from vibration. Let’s look at the headstock itself. If you put the OEM headstock right alongside the GlockCNC headstock, you immediately seem the difference. The OEM looks almost wimpy by comparison. The GlockCNC casing has a lot more metal in it and allows for much bigger OD bearing. This allows for a larger spindle to be utilized. Let us talk about these spindles for a watchmakers lathe. Watchmakers like precision. This makes perfect sense because all those gears are pounding against each other and still must keep accurate time.

When accuracy of your lathe cuts to down, so does everything else. Until now, there weren’t a lot of options to turn a Taig into a machine similar to a excellent lathe. That changed over the last few years. A small company in Michigan called GlockCNC.com currently makes strategically done upgrades. Two upgrades in particular. First, they have produced there own heavy duty headstock and spindles. Is this good news for the watchmakers and clockmakers? Their normal spindle has a 30mm OD and they shrink fit the bearings into the spindle.

For those in LEESVILLE, CA They offer ER25, ER32, ER40 as well as the enormous ER50 collet chuck spindles. The through hole is from .30″ to .89″, determined by which ER spindle arbor you choose. I would suspect that most watch makers will use the ER25 or ER32. This allows for very precision workpiece. Plus, the collets can be found anywhere. GlockCNC offers .0002″ TIR collets (which is about as precise as you’ll get). On top of that, they also have adjustable ER nuts to dial out any residual runout. Of course, when you work piece isn’t straight, then it’ll make it a challenge to dial out the runout. But, what can be done is make your cut, turn the piece around then use the adjustable nut to dial out the TIR.

Video: watchmaker lathe in LEESVILLE