Best Watchmaker Lathe-Mill For Sale near LA SIERRA CA

In general, for the watch maker, they offer the perfect setup. Additionally, the price is much better than a Swiss machine. I can not foresee a watchmaker needing more than the 750 watt model. In accordance with GlockCNC.com, they could sell you the lathe complete with their. Watchmakers like precision. This makes perfect sense because all those gears are pounding against each other and still must keep accurate time.

When accuracy of your lathe cuts down, so does everything else. Until now, there weren’t a great deal of options to turn a Taig into a machine much like a quality lathe. That’s all changed over the last few years. A small company in Michigan called GlockCNC.com now makes smartly done upgrades. Two upgrades in particular. To begin with, they have produced there own heavy duty headstock and spindles. Why is this great news for the watchmaker and clockmakers? Normally, the OEM Taig lathe uses a very tiny dovetail system for it’s headstock. GlockCNC.com utilizes a much thicker chuck of aluminum without a”air gap” between the headstock and the bed. This allows for better energy handling from vibration. Let’s look at the headstock itself. If you put the OEM headstock right next to the GlockCNC headstock, you immediately seem the difference. The GlockCNC casing has far more metal inside and allows for much bigger OD bearing. This, then, allows for a larger spindle to be used. Let’s talk about these spindles for a watchmakers lathe.

Their normal spindle includes a 30mm OD and they shrink fit the bearings into the spindle. They offer ER25, ER32, ER40 as well as the huge ER50 collet chuck spindles. The through hole is from .30″ to .89″, depending upon which ER spindle arbor you select. I would suspect that most watch makers will be using the ER25 or ER32. This allows for very precision workpiece gripping. Plus, the collets can be found anywhere. GlockCNC offers .0002″ TIR collets (that is about as precise as you will get). On top of that, they also have adjustable ER nuts to dial out any remaining runout. Of course, if you work piece is not straight, then it’ll make it a challenge to dial out the runout. But, what can be done is make your cut, turn the piece around then use the adjustable nut to dial out the TIR.

Video: watchmaker lathe in LA SIERRA