Best Watchmaker Lathe-Mill For Sale near KYBURZ CA

In general, for the watch maker, they offer the perfect installation. Additionally, the price is far better than a Swiss machine. I can’t foresee a watchmaker needing more than the 750 watt model. In accordance with GlockCNC.com, they could sell you the lathe complete with their. This makes perfect sense because those gears are pounding against each other and still need to keep accurate time.

When accuracy of your lathe cuts down, so does everything else. Until now, there weren’t a lot of options to turn a Taig into a machine similar to a Swiss excellent lathe. That changed over the last few years. A small company in Michigan called GlockCNC.com now makes smartly done upgrades. Two upgrades in particular. First, they’ve produced there own heavy duty headstock and spindles. Is this good news for the watchmaker and clockmakers? Normally, the OEM Taig lathe uses a really tiny dovetail system for it’s headstock. GlockCNC.com uses a much thicker chuck of aluminum with no”air gap” between the headstock and the mattress. This allows for better energy handling from vibration. Then let’s look at the headstock itself. If you place the OEM headstock right next to the GlockCNC headstock, you immediately seem the difference. The OEM looks almost wimpy by comparison. The GlockCNC casing has a metal inside and allows for much bigger OD bearing. This, in turn, allows for a larger spindle to be used. Let us talk about these spindles for a watchmakers lathe.

Their spindle has a OD and they shrink fit the bearings to the spindle. They offer ER25, ER32, ER40 and even the enormous ER50 collet chuck spindles. The through hole is from .30″ to .89″, determined by which ER spindle arbor you select. I would suspect that many watch makers will use the ER25 or ER32. This allows for very precision workpiece. Additionally, the collets can be found anywhere. GlockCNC offers .0002″ TIR collets (which is about as accurate as you will get). On top of that, they also have adjustable ER nuts to dial out any residual runout. Needless to say, if you work piece is not straight, then it’ll make it a challenge to dial out the runout. But, what can be done is make your cut, turn the piece around then use the adjustable nut to dial out the TIR.

Video: watchmaker mill in KYBURZ