Best Watchmaker Lathe-Mill For Sale near GRAHAM AL

All in all, for the watch maker, they offer the perfect setup. Plus, the price is far better than a Swiss machine. I can not foresee a watchmaker needing more than the 750 watt model. In accordance with GlockCNC.com, they could sell you the lathe complete with all their. Watchmakers like precision. This makes perfect sense because those gears are pounding against each other and still must keep accurate time.

When accuracy of your lathe cuts down, so does everything else. Until now, there weren’t a lot of options to turn a Taig into a machine similar to a Swiss quality lathe. That changed over the last few years. A small business in Michigan known as GlockCNC.com currently makes strategically done upgrades. Two upgrades in particular. To begin with, they’ve produced there own heavy duty headstock and spindles. Is this good news for the watchmaker and clockmakers? Typically, the OEM Taig lathe uses a very tiny dovetail system for it’s headstock. GlockCNC.com uses a much thicker chuck of aluminum without a”air gap” between the headstock and the mattress. This allows for better energy handling from vibration. Next, let’s look at the headstock itself. If you put the OEM headstock right next to the GlockCNC headstock, you immediately seem the difference. The OEM looks almost wimpy by comparison. The GlockCNC casing has a metal in it and allows for much bigger OD bearing. This allows for a larger spindle to be utilized. The simple fact of the matter is, that, more spindle mass equals better vibration dampening. Let us talk about these spindles for a watchmakers lathe.

Their spindle includes a 30mm OD and they shrink fit the bearings. They offer ER25, ER32, ER40 and even the huge ER50 collet chuck spindles. The through hole is from .30″ to .89″, determined by which ER spindle arbor you select. I would suspect that most watch makers will be using the ER25 or ER32. This allows for very precision workpiece gripping. Additionally, the collets are available anywhere. GlockCNC offers .0002″ TIR collets (which is about as precise as you will get). On top of that, they also have adjustable ER nuts to dial out any residual runout. Needless to say, when you work piece is not straight, then it will make it a challenge to dial out the runout.

Video: watchmaker mill in GRAHAM