Best Watchmaker Lathe-Mill For Sale near GARDEN CITY AL

In general, for the watchmaker near GARDEN CITY AL, they offer the perfect setup. Plus, the price is much better than a Swiss machine. I can not foresee a watchmaker needing more than the 750 watt model. According to GlockCNC.com, they can sell you the lathe complete with their. Watchmakers like precision. This makes perfect sense because all those gears are pounding against each other and still must keep accurate time. When precision of your lathe cuts down, so does everything else. Until now, there weren’t a great deal of options to turn a Taig into a machine much like a excellent lathe. That changed over the last few decades. A small company in Michigan called GlockCNC.com now makes smartly done updates.

Two upgrades specifically. First, they have produced there own heavy duty headstock and spindles. Is this great news for the watchmakers and clockmakers? Normally, the OEM Taig lathe uses a really tiny dovetail system for it’s headstock. GlockCNC.com uses a much thicker chuck of aluminum with no”air gap” between the headstock and the bed. This allows for better energy handling from vibration. Next, let’s look at the headstock itself. If you place the OEM headstock right alongside the GlockCNC headstock, you immediately seem the difference. The OEM looks almost wimpy by comparison. The GlockCNC casing has a metal inside and allows for bigger OD bearing. This allows for a larger spindle to be used. The fact of the matter is, that, more spindle mass equals better vibration dampening. Let us talk about these spindles for a watchmakers lathe.

Their spindle has a 30mm OD and they shrink fit the bearings into the spindle. They offer ER25, ER32, ER40 as well as the huge ER50 collet chuck spindles. The through hole is from .30″ to .89″, depending upon which ER spindle arbor you select. I’d suspect that many watch makers will use the ER25 or ER32. This allows for very precision workpiece. Additionally, the collets are available anywhere. GlockCNC offers .0002″ TIR collets (which is about as accurate as you’ll get). In addition to that, they also have adjustable ER nuts to dial out any remaining runout. Needless to say, if you work piece isn’t straight, then it’ll make it a challenge to dial out the runout. But, what can be done is make your cut, turn the piece around then use the adjustable nut to dial out the TIR.

Video: watchmaker mill in GARDEN CITY