Best Watchmaker Lathe-Mill For Sale near FRUITHURST AL

In general, for the watchmaker near FRUITHURST AL, they offer the perfect installation. Plus, the price is far better than a Swiss machine. Next they offer two brushless motor options; 750 watt and 1200 watt. I can’t foresee a watchmaker needing more than the 750 watt model. In accordance with GlockCNC.com, they could sell you the lathe complete with their. Watchmakers like precision. This makes perfect sense because all those gears are pounding against each other and still need to keep accurate time. When precision of your lathe cuts down, so does everything else. Until now, there weren’t a great deal of options to turn a Taig into a machine much like a excellent lathe. That changed over the past few decades. A small company in Michigan called GlockCNC.com currently makes strategically done upgrades.

Two upgrades specifically. To begin with, they’ve produced there own heavy duty headstock and spindles. Is this good news for the watchmakers and clockmakers? Firstly, let us look at the meaty headstock and how it attaches to the lathe. Normally, the OEM Taig lathe uses a very tiny dovetail system for it’s headstock. GlockCNC.com uses a much thicker chuck of aluminum with no”air gap” between the headstock and the mattress. This allows for better energy handling from vibration. Let’s look at the headstock itself. If you put the OEM headstock right alongside the GlockCNC headstock, you instantly seem the difference. The OEM looks almost wimpy by comparison. The GlockCNC casing has far more metal inside and allows for bigger OD bearing. This allows for a larger spindle to be utilized. The simple fact of the matter is, that, more spindle mass equals better vibration dampening. Let us talk about those spindles for a watchmakers lathe.

Their typical spindle has a 30mm OD and they shrink fit the bearings. They offer ER25, ER32, ER40 and even the enormous ER50 collet chuck spindles. The through hole is from .30″ to .89″, determined by which ER spindle arbor you select. I’d suspect that most watch makers will be using the ER25 or ER32. This allows for very precision workpiece. Additionally, the collets are available anywhere. GlockCNC offers .0002″ TIR collets (which is about as precise as you will get). In addition to that, they also have adjustable ER nuts to dial out any residual runout. Of course, when you work piece is not straight, then it will make it a challenge to dial out the runout. But, what can be done is make your cut, turn the piece around then use the adjustable nut to dial out the TIR.

Video: watchmaker mill in FRUITHURST