Best Watchmaker Lathe-Mill For Sale near FRANKVILLE AL

All in all, for the watch maker, they offer the perfect setup. Additionally, the price is far better than a Swiss machine.

Next they offer two brushless motor options; 750 watt and 1200 watt. I can not foresee a watchmaker needing over the 750 watt model. According to GlockCNC.com, they could sell you the lathe complete with their. Typically, the OEM Taig lathe uses a really tiny dovetail system for it’s headstock. GlockCNC.com uses a much thicker chuck of aluminum without a”air gap” between the headstock and the mattress. This allows for better energy managing from vibration. Next, let’s look at the headstock itself. If you put the OEM headstock right alongside the GlockCNC headstock, you immediately seem the difference. The GlockCNC casing has a lot more metal inside and allows for bigger OD bearing. This, then, allows for a larger spindle to be used. Let’s talk about those spindles for a watchmakers lathe. This makes perfect sense because those gears are pounding against each other and still need to keep accurate time.

When precision of your lathe cuts down, so does everything else. Until now, there weren’t a lot of options to turn a Taig to a machine similar to a Swiss quality lathe. That changed over the past few decades. A small company in Michigan known as GlockCNC.com now makes smartly done upgrades. Two upgrades in particular. First, they have produced there own heavy duty headstock and spindles. Why is this good news for the watchmakers and clockmakers? Their typical spindle includes a OD and they shrink fit the bearings into the spindle.

For those in FRANKVILLE, AL They offer ER25, ER32, ER40 as well as the enormous ER50 collet chuck spindles. The through hole is from .30″ to .89″, determined by which ER spindle arbor you choose. I’d suspect that most watch makers will be using the ER25 or ER32. This allows for very precision workpiece. Plus, the collets can be found anywhere. GlockCNC offers .0002″ TIR collets (that is about as precise as you will get). On top of that, they also have adjustable ER nuts to dial out any remaining runout. Of course, if you work piece is not straight, then it’ll make it a challenge to dial out the runout.