Best Watchmaker Lathe-Mill For Sale near FORT DAVIS AL

In general, for the watch maker, they offer the perfect setup. Plus, the price is much better than a Swiss machine.

I can not foresee a watchmaker needing more than the 750 watt model. In accordance with GlockCNC.com, they can sell you the lathe complete with all their. Firstly, let’s look at the meaty headstock and how it attaches to the lathe. Typically, the OEM Taig lathe uses a very tiny dovetail system for it’s headstock. GlockCNC.com uses a much thicker chuck of aluminum without a”air gap” between the headstock and the bed. This allows for better energy managing from vibration. Then let’s look at the headstock itself. If you place the OEM headstock right alongside the GlockCNC headstock, you immediately seem the difference. The OEM looks almost wimpy by comparison. The GlockCNC casing has far more metal inside and allows for bigger 62mm OD bearing. This, in turn, allows for a larger spindle to be used. The simple fact of the matter is, that, more spindle mass equals better vibration dampening. Let’s talk about those spindles for a watchmakers lathe. This makes perfect sense because those gears are pounding against each other and still need to keep accurate time.

When accuracy of your lathe cuts down, so does everything else. Until now, there weren’t a great deal of options to turn a Taig into a machine much like a Swiss excellent lathe. That changed over the last few years. A small business in Michigan known as GlockCNC.com now makes smartly done upgrades. Two upgrades specifically. To begin with, they’ve produced there own heavy duty headstock and spindles. Why is this good news for the watchmakers and clockmakers? Their normal spindle has a OD and they shrink fit the bearings.

For those in FORT DAVIS, AL They offer ER25, ER32, ER40 and even the huge ER50 collet chuck spindles. The through hole is from .30″ to .89″, depending upon which ER spindle arbor you choose. I’d suspect that many watch makers will be using the ER25 or ER32. This allows for very precision workpiece. Plus, the collets are available anywhere. GlockCNC offers .0002″ TIR collets (that is about as precise as you’ll get). On top of that, they also have adjustable ER nuts to dial out any residual runout. Of course, when you work piece isn’t straight, then it will make it a challenge to dial out the runout. But, what could be done is make your cut, turn the piece around then use the adjustable nut to dial out the TIR.

Video: watchmaker mill in FORT DAVIS