Best Watchmaker Lathe-Mill For Sale near FIRST NATIONAL BANK AL

All in all, for the watchmaker near FIRST NATIONAL BANK AL, they offer the perfect setup. Plus, the price is much better than a Swiss machine. Next they offer two brushless motor options; 750 watt and 1200 watt. I can’t foresee a watchmaker needing more than the 750 watt model. According to GlockCNC.com, they can sell you the lathe complete with their. Watchmakers like precision. This makes perfect sense because all those gears are pounding against each other and still need to keep accurate time. When precision of your lathe cuts down, so does everything else. Until now, there weren’t a great deal of options to turn a Taig to a machine much like a Swiss quality lathe. That changed over the last few years. A small company in Michigan known as GlockCNC.com now makes smartly done upgrades.

Two upgrades specifically. First, they have made there own heavy duty headstock and spindles. Why is this good news for the watchmakers and clockmakers? Firstly, let us look at the meaty headstock and how it attaches to the lathe. Normally, the OEM Taig lathe uses a really tiny dovetail system for it’s headstock. GlockCNC.com utilizes a much thicker chuck of aluminum without a”air gap” between the headstock and the bed. This allows for better energy handling from vibration. Then let’s look at the headstock itself. If you place the OEM headstock right next to the GlockCNC headstock, you immediately seem the difference. The OEM looks almost wimpy by comparison. The GlockCNC casing has far more metal in it and allows for bigger OD bearing. This allows for a larger spindle to be utilized. The fact of the matter is, that, more spindle mass equals better vibration dampening. Let’s talk about those spindles for a watchmakers lathe.

Their normal spindle has a 30mm OD and they shrink fit the bearings. They offer ER25, ER32, ER40 as well as the huge ER50 collet chuck spindles. The through hole is from .30″ to .89″, depending upon which ER spindle arbor you select. I’d suspect that most watch makers will be using the ER25 or ER32. This allows for very precision workpiece. Additionally, the collets can be found anywhere. GlockCNC offers .0002″ TIR collets (that is about as precise as you’ll get). On top of that, they also have adjustable ER nuts to dial out any remaining runout. Of course, if you work piece is not straight, then it will make it a challenge to dial out the runout. But, what could be done is make your cut, turn the piece around then use the adjustable nut to dial out the TIR.

Video: watchmaker lathe in FIRST NATIONAL BANK